Flywheel
Show/hide table
Illustration 1 | g01448278 |
Note: Refer to the Systems Operation/Testing and Adjusting for the correct method for flywheel runout and flywheel inspection.
(1) Put 4C-5593 Anti-Seize Compound on the 12 Point Head bolt threads before assembly. Tighten the bolts to the following torque. ...
Note: Do not use a torch to install the gear onto the flywheel.
(2) The maximum permissible temperature of the gear for installation on the flywheel is the following value. ...
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Gear Group (Front)
G3500 Engines Programming Parameters
Federal Emissions Warranty Information Federal Emission Control Warranty
Electronic Installation Guide{1900} Electronic Installation Guide{1900}
2003/12/01 A Turbine Type Air Starting Motor Is Now Used on the 3618 Engines {1451}
C32 Marine Engine Piston and Rings
C15 and C18 Engines for Caterpillar Built Machines Cooling System
C15 Petroleum Generator Set Engines Lubrication System
C15 and C18 Engines for Caterpillar Built Machines Water Temperature Regulator Housing
2003/11/01 The Air Shutoff Has Been Improved {1078}
G3500 Engines Engine Monitoring System
C7 PETROLEUM Petroleum Engine Gear Group (Front) - Install
C32 Marine Engine Flywheel Housing
Bench Test Procedure for Gear Pumps {5073} Bench Test Procedure for Gear Pumps {5073}
3612 and 3616 Fast Vessel Engines Product Lifting
Bench Test Procedure for Vane Pumps {5055} Bench Test Procedure for Vane Pumps {5055}
3116 and 3126 Marine Engines Product Storage
3406E and 3456 Generator Set Engines Coolant Level Sensor
Caterpillar On-Highway Diesel Engine Fluids Recommendations General Fuel Information
C18 Generator Set Product Description
C18 Marine Engines Plate Locations and Film Locations
3406E and C15 Marine Engines Camshaft - Remove
2003/11/01 New Start/Stop Relay Is Now Being Used on 3412C PEEC Generator Sets {4493}
3406E and C15 Marine Engines Camshaft - Install