Load Cell - Remove and Install
Removal Procedure
Show/hide table
Illustration 1 | g01032940 |
- Stop the rotation of the flywheel by pressing the "Ctrl" and the "x" keys simultaneously. Shut down the system and de-energize the system before attempting to remove the lower bearing. Refer to the, "Shutdown System" section of this manual for the proper shutdown procedure.
- Disconnect the 10-pin connector and the cable for the Load cell from the bottom of the flywheel.
- While you are holding the assembly (load cell) in place, remove the six bolts that are holding the assembly (load cell) in the lower bearing cartridge. Use one quarter turns in a star pattern until the rotor rests on the shims for the rotor. When the rotor is resting on the rotor shims remove all six screws.
Show/hide table
Illustration 2 | g01032940 |
- Carefully remove the assembly (load cell).
Do not drop the assembly.
- Remove the plate (load cell).
- Remove the shims (load cell).
Installation Procedure
- Install the following assemblies into the Bearing Cartridge: Load Cell and End Plate.
Show/hide table
Illustration 3 | g01032940 |
- Tighten the remaining 6 screws in a star pattern. Tighten the screws to 27 N·m (20 lb ft).
- Connect the 10-pin connector and the cable for the Load Cell to the flywheel.
- Energize the system according to the, "System Startup" section of this manual.
Caterpillar Information System:
Installation Guide for Particulate Trap Exhaust Filters{1091} Installation Guide for Particulate Trap Exhaust Filters{1091}
2003/12/01 New Gaskets in the Water Lines Groups {1380}
G3500 Engines Too Much Vibration
G3500 Engines Short Spark Plug Life
G3500 Engines Poor Fuel Consumption
G3500 Engines Noise Coming from Cylinder
2003/11/01 New Gasket for the Turbocharger's Water Lines {1052, 1380}
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Mechanical Noise (Knock) in Engine
G3500 Engines Low Power/Poor or No Response to Throttle
G3500 Engines Intermittent Engine Shutdown
G3500 Engines Inlet Air Temperature (High)
G3500 Engines Fuel Metering Valve
C9 Marine Engines and C9 Marine Generator Sets Camshaft Gear - Remove and Install
C32 Marine Engine Electronic Control System Components
C32 Marine Engine Fuel System
2004/01/01 An Updated Version of Troubleshooting Guide, SENR9698 is Now Available {1105, 1400}
2003/11/01 Improved Exhaust Seal for the Exhaust Manifold {1059}
C9.3 Marine Engine Auxiliary Water Pump - Remove
C7 PETROLEUM Petroleum Engine Auxiliary Water Pump - Assemble
G3500 Engines Self-Diagnostics
C9.3 Marine Engine Auxiliary Water Pump - Install
C7 PETROLEUM Petroleum Engine Auxiliary Water Pump - Disassemble
C32 Marine Engine Heat Exchanger
G3500 Engines Location of Components