Rocker Shaft - Assemble
Assembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: For information on reusability of components of the rocker shaft, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8267, "Rocker Arms and Rocker Arm Shafts for 3114 and 3116 Engines".
- Install button (6) and the retaining ring, if necessary.
Show/hide table
Illustration 1 | g00995508 |
- Place clean engine oil on a new bearing (7) prior to installation.
- Ensure that the oil hole in bearing (7) is aligned with the oil hole in the rocker arm. Hone the bearing, if necessary. Refer to the Specifications Module for the correct dimensions.
- Lubricate rocker shaft assembly (2) with clean engine oil.
Show/hide table
Illustration 2 | g00995509 |
- Install valve rocker arm (3), spacer (4), and valve rocker arm (5) on rocker shaft assembly (2) .
- Install support bracket (1) on rocker shaft assembly (2) .
End By: Install the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
Caterpillar Information System:
2003/05/12 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
G3520B Industrial Engine PWM Sensor
3116 and 3126 Truck Engines Rocker Shaft - Disassemble
3500 Marine Engines Accumulator Pressure - Test
3500B and 3500C Marine Propulsion Engines Electronic Display Module
2003/08/01 A Pin for the Rocker Shaft Is Now Available for Parts Service {1102}
2003/05/01 New Cylinder Liner {1216}
3116 and 3126 Truck Engines Rocker Shaft and Pushrod - Remove
G3304 and G3306 Engines Auxiliary Water Pump - Assemble
3054E Industrial Engine Fuel Injection Pump - Install
G3500B Engines Junction Box
3456 Generator Sets Voltage Regulators
3116 and 3126 Truck Engines Rocker Shaft and Pushrod - Install
2003/05/05 New QuickEvac High Speed Oil Change Arrangements Are Available {1325}
C4.4 (Mech) Industrial Engine Glow Plugs - Test
3500B and 3500C Marine Propulsion Engines System Overview
G3520C and G3520E Generator Set Engines Water Pump - Remove
G3520C and G3520E Generator Set Engines Water Pump - Install
G3304 and G3306 Engines Accessory Drive - Remove and Install
3054E Industrial Engine Fuel Injection Lines - Remove and Install
3618 Engine Aftercooler Core - Clean/Test
C1.5 and C2.2 Generator Generator Operation
Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202} Inspection and/or Repair Procedure to Replace Broken Crankshafts in C-15, C-16, C15, 3406C, 3406E, and 3456 Engines{1202}
G3520B Industrial Engine Electrical Power Supply