Rocker Shaft - Disassemble
Disassembly Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 6V-0083     | Emery Polishing Paper     | 1     |
Start By:
- Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: For information on reusability of components of the rocker shaft, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8267, "Rocker Arms and Rocker Arm Shafts for 3114 and 3116 Engines".
- Remove support bracket (1) from rocker shaft assembly (2) .
Show/hide table
Illustration 1 | g00995462 |
- Remove valve rocker arm (3), spacer (4), and valve rocker arm (5) from rocker shaft assembly (2) .
Note: Do not force the rocker arms from the rocker shaft assembly. If necessary, use Tooling (A) to lightly buff the surface of the shaft to aid in removal .
- Check the adjustment screws on valve rocker arm (3) and valve rocker arm (5) for damage.
- Inspect rocker shaft assembly (2) for scratches and cracks.
- Inspect bearing (7) on valve rocker arm. The bore in the rocker arm is 24.808 ± 0.20 mm (0.9767 ± 0.0079 inch). Refer to Specification, "Valve Rocker Arm and Lifters". Replace the bearing, if necessary.
Show/hide table
Illustration 2 | g00995489 |
- Ensure that button (6) on valve rocker arm (3) is not damaged. Also ensure that the retaining ring for button (6) is in place.
Caterpillar Information System:
3500 Marine Engines Accumulator Pressure - Test
3500B and 3500C Marine Propulsion Engines Electronic Display Module
2003/08/01 A Pin for the Rocker Shaft Is Now Available for Parts Service {1102}
2003/05/01 New Cylinder Liner {1216}
3116 and 3126 Truck Engines Rocker Shaft and Pushrod - Remove
G3304 and G3306 Engines Auxiliary Water Pump - Assemble
3054E Industrial Engine Fuel Injection Pump - Install
G3500B Engines Junction Box
3456 Generator Sets Voltage Regulators
TK711, TK721, TK722 and TK732 Track Feller Bunchers Oil Filter - Inspect
C15 and C18 Petroleum Generator Sets Mounting and Dismounting
C1.5 and C2.2 Marine Generator Set Engines Heat Exchanger - Install
G3520B Industrial Engine PWM Sensor
2003/05/12 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
3116 and 3126 Truck Engines Rocker Shaft - Assemble
3116 and 3126 Truck Engines Rocker Shaft and Pushrod - Install
2003/05/05 New QuickEvac High Speed Oil Change Arrangements Are Available {1325}
C4.4 (Mech) Industrial Engine Glow Plugs - Test
3500B and 3500C Marine Propulsion Engines System Overview
G3520C and G3520E Generator Set Engines Water Pump - Remove
G3520C and G3520E Generator Set Engines Water Pump - Install
G3304 and G3306 Engines Accessory Drive - Remove and Install
3054E Industrial Engine Fuel Injection Lines - Remove and Install
3618 Engine Aftercooler Core - Clean/Test