Rocker Shaft and Pushrod - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Lubricate pushrods (6) with clean engine oil. Install pushrods (6) in the cylinder head.
Note: Ensure that the pushrods are installed correctly in the socket of the valve lifters.
Show/hide table
Illustration 1 | g00827968 |
- Install caps (5) on the top of the valve stems.
- Install O-ring seal (9) on base (8) .
- Install rocker shaft assembly (4) and base (8) for the valve mechanism cover on cylinder head (7) .
- Install bolts (1) and nuts (2) finger tight.
Note: Ensure that the ends of the adjusting screws on each rocker arm are properly seated in the ends of pushrods (6) .
Note: Lubricate nuts (2) with clean engine oil before installation.
- Tighten bolts (1) on each end of the base (8) for the valve mechanism cover.
- The nut tightening sequence moves from the center of the rocker shaft outward. Tighten nuts (1) and bolts (2) evenly to a torque of 33 N·m (24 lb ft).
- Adjust the valve lash. Refer to Testing and Adjusting, "Engine Valve Lash - Inspect/Adjust" for the correct procedure to adjust the valve lash.
- The torque for adjusting screws (3) is 14 N·m (10 lb ft).
End By: Install the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Caterpillar Information System:
C1.5 and C2.2 Marine Generator Set Engines Valve Mechanism Cover - Remove and Install
C1.5 and C2.2 Marine Generator Set Engines Crankshaft Pulley - Remove and Install
Installation of Fuel/Water Separator{1260, 1263} Installation of Fuel/Water Separator{1260, 1263}
3500B and 3500C Marine Propulsion Engines System Configuration Parameters
C1.5 and C2.2 Marine Generator Set Engines Flywheel Housing - Remove and Install
3406C Generator Sets Sensors and Electrical Components
C1.5 and C2.2 Generator Set Engines Fuel Injection Pump - Install
C1.5 and C2.2 Generator Set Engines Fuel Injection Lines - Remove and Install
3456 Generator Sets Generator Installation
3500B Engines for Caterpillar Built Power Modules Thermostatic Valve
3500B and 3500C Marine Propulsion Engines Engine Monitoring System
3456 Generator Sets Generator Identification
3456 Generator Sets Engine Shutoffs and Engine Alarms
3456 Generator Sets Overspeed
3412C Generator Sets Starting the Engine - EMCP II and EMCP II+ (If Equipped)
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Remove
C1.5 and C2.2 Marine Generator Set Engines Cylinder Head - Install
C15 and C18 Petroleum Generator Sets Generator Operation
C1.5 and C2.2 Generator Set Engines Engine Oil Pan - Remove and Install
Caterpillar On-Highway Diesel Engine Fluids Recommendations Cold Weather Lubricants
C1.5 and C2.2 Marine Generator Set Engines Pistons and Connecting Rods - Install
C1.5 and C2.2 Generator Set Engines Crankshaft Main Bearings - Remove
C1.5 and C2.2 Generator Set Engines Crankshaft - Install
Caterpillar On-Highway Diesel Engine Fluids Recommendations Coolant Recommendations