Pistons and Connecting Rods - Remove
拆卸步骤
开始:
- 拆下缸盖。 请参阅拆解和组装, "缸盖 - 拆卸"。
- 拆卸发动机机油泵。 请参阅拆解和组装, "发动机机油泵 - 拆卸"。
- 卸下活塞冷却喷嘴。 请参阅拆解和组装, "活塞冷却喷嘴 - 拆卸和安装"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 转动曲轴,直到连杆盖位于下止点。
Show/hide table
图 1 | g01126088 |
- 在所有连杆和连杆盖 (2) 上作识别标记。 该编号必须与气缸号一致。
- 拆下螺栓 (1) 和连杆盖 (2) 。
- 从连杆盖 (2) 上拆下连杆轴承 (4) 的下半部分。
Show/hide table
图 2 | g01126089 |
- 推动活塞和连杆远离曲轴。 从连杆 (3) 上拆下连杆轴承 (4) 的上半部分。
- 从缸体上拆下活塞和连杆 (3) 。
Caterpillar Information System:
C15 On-Highway Engines Lubrication System
3044C Industrial Engine Cooling System Coolant (DEAC) - Change
3044C Industrial Engine After Stopping Engine
3044C Industrial Engine and Engines for Caterpillar Built Machines Glow Plugs
C7 On-highway Engine Engine Oil Filter Base - Remove
3516B HD Generator Set Overhaul (Top End)
3126B Petroleum Engine Excessive White Smoke
G3304 and G3306 Engines Vibration Damper and Pulley - Remove
3516B HD Generator Set Overhaul (Major)
C9 Urban Transit Bus Engine Air Inlet Cover - Install
C9 Urban Transit Bus Engine Air Inlet Cover - Remove
C1.5 and C2.2 Generator General Information
G3304 and G3306 Engines Vibration Damper and Pulley - Install
C7 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Install
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Remove
C7 Engines for Caterpillar Built Machines Connecting Rod Bearings - Remove
3044C Industrial Engine Engine Oil and Filter - Change
C7 On-highway Engine Connecting Rod Bearings - Install
C7 Engines for Combat and Tactical Vehicles System Overview
C7 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Remove
G3304 and G3306 Engines Crankshaft Front Seal and Wear Sleeve - Install
C7 and C9 On-Highway Engines Engine Speed/Timing Sensor - Calibrate
C7 Engines for Caterpillar Built Machines Crankshaft Main Bearings - Install
C7 Marine Engines Crankshaft - Remove