0110-11 Very High Coolant Temperature (61)
产生此代码的情况:
发动机控制模块 (ECM) 检测到以下情况：
- 发动机冷却液温度高于 110 °C (230 °F) 20 秒。
- 发动机至少已运转 30 秒钟。
系统响应:
在卡特彼勒电子技师 (ET) 中，在"发动机冷却液温度"状态的旁边将会显示 "诊断"。 检查发动机指示灯和报警灯将点亮。
注: 如果安装了冷却液温度过高灯，点亮的是冷却液温度过高灯而非报警灯。
清除该诊断代码时需要使用客户密码。
在 110 °C (230 °F)时每增加 1 °C (1.8 °F)，发动机额定功率降低 25%，一直到 100%。 额定功率降低到 100% 意味着 ECM 将使用默认的扭矩图表而且车速将被限制为 72.4 km/h (45 mph)。
注: 如果 "发动机监测"被设定为 "停机"，当此代码变为激活状态 20 秒后发动机将停机。
注: 如果 "发动机监测"参数被设定为 "警告"，发动机功率不受影响。
测试步骤 1. 检查冷却系统
请参阅测试和调整, "冷却系统 - 测试"。
结果:
- 正常 - 停止
Caterpillar Information System:
C11, C13 and C15 On-highway Engines 0110-00 High Coolant Temperature Warning (61)
G3500 Generator Sets After Starting Engine
G3500 Generator Sets Starting the Engine
PMG3516 Power Module Before Starting Engine
C9 Urban Transit Bus Engine Water Pump - Inspect
C9 Urban Transit Bus Engine Walk-Around Inspection
C7 and C9 On-Highway Engines Input Selections
3126B and 3126E On-highway Engines 0071-14 PTO Shutdown (47)
3126B and 3126E On-highway Engines 0071-01 Idle Shutdown (47)
3126B and 3126E On-highway Engines 0071-00 Idle Shutdown Override (01)
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Battery or Battery Cable - Disconnect
C1.5 and C2.2 Generator Sets Alternator Belt - Inspect/Adjust/Replace
C1.5 and C2.2 Generator Sets Cooling System Coolant (ELC) - Change
797 Off-Highway Truck Steering System Operational Checks
3056E Industrial Engine Air Compressor - Remove and Install
G3500 Generator Sets Generator Operation
797B Off-Highway Truck Steering System Steering System
C11, C13 and C15 On-highway Engines Ignition Keyswitch Circuit and Battery Supply Circuit - Test
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Fumes Disposal Filter - Drain
C9 Urban Transit Bus Engine Air in Fuel - Test
C9 Urban Transit Bus Engine Electronic Unit Injector - Test
C9 Urban Transit Bus Engine Fuel System Pressure - Test
C9 Urban Transit Bus Engine Inlet Manifold Pressure - Test
C9 Urban Transit Bus Engine Aftercooler - Test