Pistons and Connecting Rods - Disassemble
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1U-6683 | Ring Expander | 1 |
B | 1P-1857 | Retaining Ring Pliers | 1 |
C | 1P-0510 | Driver Group | 1 |
Start By:
- Remove the pistons and the connecting rods. Refer to Disassembly and Assembly, "Piston and Connecting Rods - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the connecting rod bearing from the connecting rod.
Show/hide table
Illustration 1 g00964649 - Use Tooling (A) in order to remove compression rings (1) and (2), and oil control ring (3) from piston (6).
- Use Tooling (B) in order to remove retaining rings (8) that hold the piston pin in position.
- Remove piston pin (7) from the piston.
Note: If the piston pin cannot be removed by hand, heat the piston to a temperature of
45 ± 5 °C (113 ± 9 °F) . Do not use a torch to heat the piston. - Use Tooling (C) and a suitable press in order to remove bushing (4) from connecting rod (5).
- Repeat Steps 1 through 5 in order to disassemble the remaining pistons and connecting rods.
Caterpillar Information System:
3056E Industrial Engine Pistons and Connecting Rods - Remove
3406E, C12, C15 and C18 Marine Engines Engine Pressure Sensor Open or Short Circuit - Test
3056E Industrial Engine Connecting Rod Bearings - Install
3056E Industrial Engine Connecting Rod Bearings - Remove
C9 Urban Transit Bus Engine Water Pump - Test
C9 Urban Transit Bus Engine Cooling System - Test
G3500B Engines Power Supply
3126B Truck Engine Maintenance Interval Schedule - Engines With a Deep Oil Sump
3126B Truck Engine Maintenance Interval Schedule - Engines With a Shallow Oil Sump
3126B Truck Engine Safety Messages
C9 Urban Transit Bus Engine Noise from Injectors with Key Switch ON
3054C Industrial Engine Aftercooler Core - Clean/Test
3056E Industrial Engine Pistons and Connecting Rods - Assemble
3056E Industrial Engine Pistons and Connecting Rods - Install
3126B Marine Engines Transmission Oil Temperature Sensor Open or Short Circuit - Test
2002/12/01 A New Top Piston Ring Promotes Reduced Cylinder Liner Wear {1214, 1215}
3126E Truck Engine Electrical System
C4.4 (Mech) Industrial Engine Electric Starting System - Test
G3500 Engines Vibration Damper Guard
G3600 Engines Exhaust Manifold
3126E Truck Engine Basic Engine
3126E Truck Engine Vibration Damper - Check
3056E Industrial Engine Air Inlet Heater - Remove and Install
C7 On-highway Engine Valve Mechanism Cover