Fan Drive - Remove and Install
拆卸步骤
开始:
- 拆下风扇。 请参阅拆解和组装, "风扇 - 拆卸和安装"。
- 从风扇驱动装置 (2) 上拆下调整螺钉 (1) 。
Show/hide table
图 1 | g00944500 |
- 拆下风扇驱动装置 (2) 。
安装步骤
- 将风扇驱动装置 (2) 定位到缸体的前端面上,使轴朝向安装法兰的底部。
Show/hide table
图 2 | g00944500 |
- 安装调整螺钉 (1) 。 以 44 N·m (32 lb ft) 的扭矩拧紧调整螺钉。
End By: 安装风扇。 请参阅 拆解和组装, "风扇 - 拆卸和安装"。
Caterpillar Information System:
C18 Generator set and C18 Marine Engines Vibration Damper and Pulley - Remove and Install
C7 and C9 On-Highway Engines Transmission (AT/MT/HT) Relay Circuit - Test
C9 Marine Auxiliary and Generator Set Engines Heat Exchanger - Inspect
C9 Marine Auxiliary and Generator Set Engines Fuel System Secondary Filter - Replace
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Bearing Retainer - Remove and Install
C9 Marine Auxiliary and Generator Set Engines Zinc Rods - Inspect/Replace
UPS 250 and UPS 300 Uninterruptible Power Supplies Bearing Retainer - Remove and Install
3126B and 3126E On-highway Engines 0030-13 PTO Throttle out of calibration (29)
3126B and 3126E On-highway Engines 0030-08 PTO Throttle signal invalid (29)
C9 Marine Auxiliary and Generator Set Engines Engine Oil Sample - Obtain
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0231-02 J1939 Data Incorrect (58)
C7 and C9 On-Highway Engines 0111-14 Low Coolant Level Warning
3056E Industrial Engine Fuel Injection Pump - Remove
3056E Industrial Engine Fuel Injection Pump - Install
3406E, C12, C15 and C18 Marine Engines Engine Speed/Timing Sensor - Calibrate
3126B and 3126E On-highway Engines PTO Switch ON Lamp Circuit - Test
2003/02/01 A New Spark Plug Is Available For Use In Applications That Use Bio-Gas Fuel {1555}
2003/01/01 New Ignition Control Groups Are Available And A New Wiring Harness Is Available To Connect The Ignition Control Group To The Display Module For The Caterpillar Ignition System (CIS) {1550}
2002/12/01 A New Service Manual, RENR2495, "3600 Engines PanelView Monitor" is Available {0374}
2003/01/01 227-4236 Electrical Cable is Available {4459}
2003/02/01 Correction to Systems Operation/Testing and Adjusting, RENR5908-01 , "Procedure for Engine Timing" {1000, 1900}
2003/02/01 Correction to Troubleshooting, RENR5910-01 , "Engine Speed/Timing Sensor" {1907, 1912}
C7 and C9 On-Highway Engines Engine/Gear Parameters
3054C Industrial Engine Aftercooler Core - Clean/Test