3056E Industrial Engine Caterpillar

Fuel Injection Nozzles - Remove

Usage:

3056E 356

Removal Procedure

Start By:

Remove the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".

Show/hide table

NOTICE

Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Show/hide table

NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates.

Show/hide table




Illustration 1	g00902563

Loosen threaded nut (1) on the fuel injection nozzle.
Show/hide table

Illustration 2 g00902564
Remove fuel injection nozzle (2) from the cylinder head.
Remove seat washer (3).
Note: If the original seat washer is not removed, the projection of the fuel injection nozzle will be incorrect when a new seat washer is installed.

Caterpillar Information System:

G3520C and G3520E Generator Set Engines Cat Data Link - Test

G3520B Industrial Engine MID 036 - CID 1720 - FMI 09 Turbocharger Compressor Bypass Valve Actuator not communicating on link

G3520B Industrial Engine MID 036 - CID 1440 - FMI 09 Unable to communicate with Throttle Actuator Drv

G3408C and G3412C Engines Engine Oil Filter Base

G3406 Engines Engine Oil Filter Base

2002/12/16 New Water Seals Provide Increased Stability At Higher Temperatures {1100, 1124}

2010/10/06 New Water Seals Provide Increased Stability At Higher Temperatures {1100, 1124}

G3408C and G3412C Engines Cylinder Head

C7 and C9 On-Highway Engines ECM Memory - Test

C7 and C9 On-Highway Engines Engine Temperature Sensor Open or Short Circuit - Test

G3516B Engines Exhaust Port Temperature (High)

G3516B Engines Engine Coolant Temperature (High)

3056E Industrial Engine Fuel Injection Nozzles - Install

Test Sequence for Pencil Type Fuel Nozzles{1254} Test Sequence for Pencil Type Fuel Nozzles{1254}

C7 and C9 On-Highway Engines Air Inlet Heater Circuit - Test

G3500 Engines Exhaust Manifold - Dry

2002/12/01 New Thermocouples Are Used To Measure The Engine Exhaust Temperature {1059, 1919}

SR4 HV and SR4B HV Generators Generator Set - Test

3056E Industrial Engine Exhaust Manifold - Remove and Install - Three-Piece Exhaust Manifold

G3500 Engines Exhaust Manifold - Dry

G3520C and G3520E Engines Spark Plug

416C, 426C, 428C, 436C and 438C Backhoe Loaders Emissions Certification Film

G3408 and G3412 Engines Idler Gear Assembly

2002/11/01 A New Fuel Transfer Pump Group Is Used {1256}