0041-03 8 Volt Supply voltage high (21)
产生此代码的情况:
发动机控制模块 (ECM) 检测到以下情况:
- 8 伏电源高于 8.5 VDC 超过 1 秒。
- ECM 已被通电至少 3 秒。
系统响应:
ECM 将记录诊断代码并触发快照。 该诊断代码为激活状态的同时,检查发动机指示灯亮起。 如果电压没有高于 12 或 13 VDC,激活的诊断代码可能不会对发动机的响应造成任何明显的影响。
发动机可能会被限制在低怠速。
注: 8 伏电源为油门踏板位置传感器供电。
测试步骤 1. 进行以下的诊断步骤: 油门踏板(油门)位置传感器电路 - 测试
结果:
- 正常 - 停止
Caterpillar Information System:
G3520C and G3520E Engines Engine Design
C11 and C13 Engines Piston Cooling Jet
3406E, C-10 and C-12 On-highway Engines 0190-02 Primary Engine Speed Loss of Signal (34)
C7 and C9 On-Highway Engines 0190-11 Primary Engine Speed no pattern (34)
G3500 Engines Gas Pressure Regulator
G3500 Engines Gas Pressure Regulator
3126B Marine Engines CID 0177 FMI 04 Transmission Oil Temperature short to ground
3126B Marine Engines CID 0177 FMI 03 Transmission Oil Temperature open/short to +batt
3054C Engines for Caterpillar Built Machines Fuel System
G3520C and G3520E Generator Set Engines Valve Lash and Valve Bridge Adjustment
G3520C and G3520E Generator Set Engines Measuring Inlet Manifold Temperature
C9 On-highway Engines Starting the Engine
C9 Marine Engines and C9 Marine Generator Sets Housing (Front)
3126B and 3126E On-highway Engines 0041-04 8 Volt Supply voltage low (21)
3406E, C-10 and C-12 On-highway Engines 0121-06 Low/High Retarder current high (14)
3406E, C-10 and C-12 On-highway Engines 0121-05 Low/High Retarder current low (14)
C7 and C9 On-Highway Engines 0042-11 Injection Actuation Pressure output fault
120H and 135H Motor Graders Seat Belt
C9 On-highway Engines Fuel System - Prime
3126B and 3126E On-highway Engines 0043-02 Key Switch Fault (71)
3406E, C-10 and C-12 On-highway Engines 0122-06 Med/High Retarder current high (14)
3406E, C-10 and C-12 On-highway Engines 0122-05 Med/High Retarder current low (14)
3406E, C-10 and C-12 On-highway Engines 0190-00 Engine Overspeed Warning (35)
G3520C and G3520E Generator Set Engines Engine Monitoring System