0022-13 Engine Speed Signal Calibration Not Performed (42)
产生此代码的情况:
发动机控制模块 (ECM) 检测到以下情况：
- 从未对新 ECM 进行过正时标定或正时偏离超过 3 度。
系统响应:
此代码将不会为记录状态。 该诊断代码为激活状态的同时，检查发动机指示灯亮起。 ECM 使用默认的正时。
发动机可能运转粗暴和/或排气冒白烟。
测试步骤 1. 进行以下的诊断步骤: 发动机转速/正时传感器 - 标定
结果:
- 正常 - 停止
Caterpillar Information System:
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0022-11 Primary to Secondary Engine Speed Signal Calibration (42)
3512B Marine Auxiliary Engine Too Much Vibration
3406E, C-10 and C-12 On-highway Engines 0168-02 ECM Battery Power Intermittent (51)
C7 On-highway Engine Reference Material
C7 and C9 On-Highway Engines 0164-11 Injection Actuation Pressure system fault (39)
C7 and C9 On-Highway Engines 0164-04 Injection Actuation Pressure voltage low (15)
C7 and C9 On-Highway Engines 0164-03 Injection Actuation Pressure voltage high (15)
3512B Marine Auxiliary Engine Fuel in Cooling System
C7 and C9 On-Highway Engines 0164-02 Injection Actuation Pressure Signal Erratic (15)
3512B Marine Auxiliary Engine Factory Passwords Worksheet
C7 and C9 On-Highway Engines 0164-00 Excessive Injection Actuation Pressure (17)
G3612 and G3616 Engines Cylinder Head - Install
G3520C and G3520E Generator Set Engines Electrical Connectors
C7 Urban Transit Bus Engines Electrical System
C7 Engines for Combat and Tactical Vehicles Safety Messages
C7 Urban Transit Bus Engines Model View Illustrations
3618 Engine Flywheel and Ring Gear - Remove and Install
2002/10/21 The Procedure For Tightening The Clamping Bolt For The Unit Injector Has Changed {1250, 1290}
2002/11/01 The Procedure For Tightening The Clamping Bolt For The Unit Injector Has Changed {1250, 1290}
2002/10/01 The Procedure For Tightening The Clamping Bolt For The Unit Injector Has Changed {1250, 1290}
C11, C13 and C15 On-highway Engines Injector Solenoid Circuit - Test
C11 and C13 Engines Turbocharger
2007/07/02 A New Ignition Transformer Group And A New Spark Plug Are Used {1550, 1555, 1561}
C7 and C9 On-Highway Engines 0100-11 Very Low Oil Pressure (46)