Manual Barring Group - Air Interlock
Show/hide table
 | |
| Illustration 1 | g00909617 |
(1) Grease fitting
While shaft (2) is locked in the retracted position by the stem (3), add 1P-0808 Multipurpose Grease until the grease is visible at the gear end of the shaft.
(2) Shaft
(3) Stem
(4) Guide
- Tighten the guide to the following torque: ... 270 ± 25 N·m (200 ± 18 lb ft)
(5) Bracket
(6) Bracket
Bracket (6) must be attached to bracket (5) prior to installing shaft (2).
Caterpillar Information System:
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Electrical System
Torque Specifications Ground Engaging Tool (G.E.T.) Fasteners
Torque Specifications Bulkhead Nuts
Torque Specifications Air Brake Fittings
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Alternator and Regulator
2002/08/01 Relocation Of The Service Center For 3600 Fuel Injectors {1254}
G3500B Engines Electronic Control Module (ECM) - 20 Cylinders
2002/08/01 2002A Service Pack 1 for Caterpillar Electronic Technician (Cat ET) is now available {0785}
C9 Urban Transit Bus Engine Customer Specified Parameters Table
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Engine Oil Filter
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Engine Oil Relief Valve
C9 Marine Auxiliary and Generator Set Engines Aftercooler Condensate Drain Valve - Inspect/Clean
C-18 Truck Engines Engine Operation
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fuel System - Prime
C-15 Truck Engine Electric Starting Motor
C-18 Truck Engines Customer Specified Parameters
797 and 797B Off-Highway Truck Power Train Electronic Control System Electronic Control Module (ECM) - Flash Program
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fuel System
2002/08/01 Guidelines for Water Pump Visual Inspection {1361}
G3500B Engines Crankshaft Position for Valve Lash Setting
2002/08/01 The Routing Has Been Changed For The New Vent Line In The Oil Level Regulator Groups {1334}
C-10, C-12 and C-15 On-highway Engines 0110-11 Very High Coolant Temperature (61)
C-10, C-12 and C-15 On-highway Engines 0110-00 High Coolant Temperature Warning (61)
797 Off-Highway Truck Hydraulic System Screen (Hoist)