3412E, C30 and C32 Marine Engines Caterpillar


Unit Injector Hydraulic Pump - Install

Usage:

3412E 9KS

Installation Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.



NOTICE

Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.




    Illustration 1g01094365

  1. Use a suitable lifting device to position unit injector hydraulic pump (2) and the O-ring seal on the engine. The weight of unit injector hydraulic pump (2) is approximately 27 kg (60 lb).

  2. Install bolts (5).


    Illustration 2g01094363

  3. Install support bracket (4) on unit injector hydraulic pump (2).


    Illustration 3g00884299

  4. Connect harness assemblies (3).

  5. Connect tube assembly (1) to unit injector hydraulic pump (2).

End By:

  1. Install the fuel transfer pump. Refer to Disassembly and Assembly, "Fuel Transfer Pump - Install".
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.