3056E Industrial Engine Caterpillar

Fuel Injection Nozzles

Usage:

Show/hide table




Illustration 1	g00894396

(1) Gland nut ... 40 N·m (30 lb ft)

Note: When the fuel injection nozzle is installed, put a 2 mm (0.08 inch) bead of 4C-5591 Anti-Seize Compound on the first two threads of the gland nut. Do not rotate the fuel injection nozzle after installation.

(2) Wire clip

(3) Seat washer

Remove the original seat washer from the threaded hole for the fuel injection nozzle which is located in the cylinder head. If the original seat washer is not removed, the projection of the nozzle will be incorrect when a new seat washer is installed. Do not reuse seat washer (3).

Opening pressure of the fuel injection nozzle ... 25338 ± 345 kPa (3675 ± 50 psi)

Bench test the fuel injection nozzles at the following temperature. ... 18° to 20°C (64° to 70°F)

Show/hide table

NOTICE

Do not use dirty test fluids when you test fuel injection nozzles. Also, do not test fuel injection nozzles unless you have the correct service tools.The use of dirty test fluids and the use of incorrect service tools will result in damage to fuel injection nozzles.

Refer to Testing and Adjusting, "Fuel System" for additional information.

Show/hide table

NOTICE

Ensure that the new fuel injection nozzles have the same identification code as the previous fuel injection nozzles in the cylinder head. If the fuel injection nozzles have an incorrect identification code, damage to the engine may occur.

Leakage in 10 seconds ... 0 drops