Coupling - Remove
Removal Procedure
Start By:
- Remove the generator. Refer to Disassembly and Assembly, "Generator - Remove".
Show/hide table
| TOOLS NEEDED | |
| Tool | Quantity |
| Acetylene Torch with a Rosebud Tip | 2 |
| Heat Resistant Gloves | 1 |
Show/hide table
 | |
| Illustration 1 | g00615745 |
- Simultaneously, heat the two opposite ends of the drive coupling. Use two acetylene torches that are equipped with rosebud tips. This method will quickly heat the coupling. Heat the coupling for three to five minutes. Do not overheat the coupling.
- Slide the coupling off the rotor shaft.
Show/hide table
 |
Always wear protective gloves when handling parts that have been heated. |
 |
Show/hide table
 | |
| Illustration 2 | g00615513 |
Caterpillar Information System:
2002/03/01 Caterpillar Electronic Technician (ET) Software Is Now Available For G3400 Engines And G3500 Engines That Are Equipped With An Electronic Ignition System (EIS) Or Air/Fuel Ratio Controls {0785}
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Programming Parameters
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Modes Of Operation
2002/03/25 A List Of Contacts For Caterpillar Product Support Is Available {1000, 4450, 7000}
2002/03/01 A List Of Contacts For Caterpillar Product Support Is Available {1000, 4450, 7000}
3500 Industrial Engine Attachments Troubleshooting
3126B Truck Engine Exhaust Particulate Filter - Clean
3126B Truck Engine Exhaust Particulate Filter - Test
3412E and C30 Engines Engine Design
3500B Engines Auxiliary Drive Pulley
3126B Marine Engines Coolant Temperature Is Too High
3176C and 3196 Engines for Caterpillar Built Machines Connecting Rod
3412E and C30 Engines Connecting Rod
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies User Interface for Multiple Module Unit
G3612 and G3616 Engines Water Pump Pressure Switch - Remove and Install
3176C and 3196 Engines for Caterpillar Built Machines Connecting Rod
Setup of the Machine Security System{7631} Setup of the Machine Security System{7631}
G3612 and G3616 Engines Integrated Combustion Sensing Module (ICSM) - Remove and Install
2002/03/01 New Specification For The Minimum Fuel Pressure At The Inlet To The Fuel Transfer Pump {1274}
G3612 and G3616 Engines Electronic Control Module - Remove and Install
3056E Industrial Engine Exhaust Manifold
G3612 and G3616 Engines Inlet Air Temperature Sensor - Remove and Install
2002/03/01 Change to Disassembly and Assembly Manual {1157}
3500 Generator Set Engines Time Delay Relay