Inlet Manifold - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install two guide bolts (7) into the cylinder head, as shown. The guide bolts are used to keep gasket (6) and air inlet manifold (5) in position on the cylinder head during installation.
Show/hide table
Illustration 1 | g00810967 |
- Put gasket (6) in position on the engine.
- Put air inlet manifold (5) in position on the engine.
- Install six of the eight bolts (3) and remove two guide bolts (7). Install the remaining two bolts (3) .
Show/hide table
Illustration 2 | g00810248 |
- Install tube (4) for the engine oil level gauge.
- Tighten bolts (3) to a torque of 22 N·m (16 lb ft).
- Install breather tube (1) onto the engine.
Show/hide table
Illustration 3 | g00810913 |
- Install coolant tube (2) onto the engine.
End By:
- Install the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".
- Install the air inlet elbow. Refer to Disassembly and assembly, "Air Inlet Elbow - Remove and Install".
Caterpillar Information System:
G3500 Engines Cooling System
3034 Marine Engine Alternator - Remove and Install
G3500 Engines Turbocharger
G3500 Engines Exhaust Manifold
3034 Marine Engine Electric Starting Motor - Remove and Install
HDB Series and M1 Series Heavy Duty Brushless Alternators Alternator
3034 Marine Engine - Installation Guide Engine Electrical System
3034 Marine Engine Valve Mechanism Cover - Remove and Install
G3500 Engines Aftercooler
37-MT, 41-MT, and 42-MT Series Starting Motors Starting Motor - Assemble - 42-MT
3034 Marine Engine Crankcase Breather - Remove and Install
3034 Marine Engine Auxiliary Water Pump - Assemble
3034 Marine Engine Engine Oil Pan - Remove and Install
3034 Marine Engine V-Belts - Remove and Install
3126B Marine Engines Electrical Connectors and Functions
3034 Marine Engine Coolant Temperature Sensor - Remove and Install
CONVERSION CHART{0374} CONVERSION CHART{0374}
3064 and 3066 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
3126B Marine Engines Engine Wiring Information
2001/07/16 New Electronic Tachometers Have Different Connection To Wiring Harness {7462}
3034 Marine Engine Exhaust Elbow - Remove and Install
Chart for Heli-Coil Repair {0676} Chart for Heli-Coil Repair {0676}
G3500 Engines Exhaust Bypass Valve
69D, 769D, 773D, 773E, 776D and 777D Off-Highway Trucks and 771D, 775D and 775E Quarry Trucks Power Train Electronic Control System General Information