Inlet Manifold - Remove
Removal Procedure
Start By:
- Remove the air inlet elbow. Refer to Disassembly and Assembly, "Air Inlet Elbow - Remove and Install".
- Remove the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove breather tube (1) from the engine.
Show/hide table
Illustration 1 | g00810913 |
- Remove coolant tube (2) from the engine.
- Remove eight bolts (3) from air inlet manifold (5) .
Show/hide table
Illustration 2 | g00810248 |
The crankcase breather is removed for illustration purposes. |
- Remove tube (4) for the engine oil level gauge.
- Remove air inlet manifold (5) and gasket (6) from the engine. Check the condition of gasket (6). If gasket (6) is worn or damaged, use a new part for replacement.
Show/hide table
Illustration 3 | g00810267 |
Caterpillar Information System:
3512B Marine Auxiliary Engine MID 047 - CID 0190 - FMI 07 Primary Speed Sensor misinstalled
3034 Marine Engine - Installation Guide Fuel System
3126B Marine Engines Glossary
G3600 Engines Engine Design
3512B Marine Auxiliary Engine MID 047 - CID 0342 - FMI 07 Secondary Speed Sensor misinstalled
G3304 and G3306 Engines Basic Engine
3512B Marine Auxiliary Engine MID 047 - CID 0248 - FMI 09 CAT Data Link not communicating
37-MT, 41-MT, and 42-MT Series Starting Motors Pinion Clearance - Adjust
Product Link 151/201 Wiring Harness (Open Circuit) - Test
3034 Marine Engine Exhaust Manifold - Remove and Install
3126B Marine Engines System Overview
3034 Marine Engine Heat Exchanger - Install
3500B and 3500 Marine Propulsion Engines with EUI Option Centrifugal Oil Filter - Inspect
3034 Marine Engine Engine Oil Cooler - Remove
3034 Marine Engine Engine Oil Cooler - Install
3034 Marine Engine Marine Transmission Oil Cooler Core - Remove and Install
G3304 and G3306 Engines Restriction of Air Inlet and Exhaust
37-MT, 41-MT, and 42-MT Series Starting Motors Starting Motor - Assemble - 37-MT and 41-MT
G3304 and G3306 Engines Measuring Inlet Manifold Temperature
3034 Marine Engine Auxiliary Water Pump - Remove
3034 Marine Engine Auxiliary Water Pump - Install
3034 Marine Engine Auxiliary Water Pump - Disassemble
G3304 and G3306 Engines Measuring Inlet Manifold Pressure
37-MT, 41-MT, and 42-MT Series Starting Motors Starting Motor - Disassemble - 42-MT