Engine Speed Sensor
Show/hide table
Illustration 1 | g01365716 |
While the engine is stopped, install the speed sensor group into the 5/8 threaded hole. Once the speed sensor group is in contact with the flywheel ring gear, turn the speed sensor group counterclockwise to the following distance. ... 180 ± 36 degrees
(A) Clearance between speed sensor group and flywheel ring gear ... 0.55 to 0.83 mm (0.022 to 0.033 inch)
(1) Torque for the locknut ... 49 ± 7 N·m (36 ± 5 lb ft)
Caterpillar Information System:
2001/06/01 A New Electrical System Schematic Is Available For The Marine Monitoring System II And The Generator Monitoring System {1901, 7490}
Wabco Air Compressors Cooling of the Air Compressor
3054E and 3056E Industrial Engines Air Compressor Filter - Clean/Replace - If Equipped
G3600 Engines Fuel System
3034 Marine Engine Heat Exchanger - Test
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Component Descriptions
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Circuit Descriptions
Wabco Air Compressors Air Induction
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Power Sources
3406E and C15 Marine Engines Turbocharger - Remove
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply General Information
G3304 and G3306 Engines Flywheel Housing
G3600 Engines Ignition System
3500B and 3500B High Displacement Generator Set Engines Emergency Stop Switch (EMS II)
Wabco Air Compressors Operation of the Air Compressor
G3600 Engines Cylinder Liner
G3600 Engines Engine Governing - Adjust
3034 Marine Engine Engine Oil Cooler
3034 Industrial Engine Breather Deflector
Wabco Air Compressors No Compression of Air (Unloaded)
SPT342 Truck Mounted Pumper Before Starting Engine
SPT342 Truck Mounted Pumper Starting the Engine
G3304 and G3306 Engines Gas Shutoff Valve
3406E and C15 Marine Engines Turbocharger - Install