Injection Actuation Pressure Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect harness assembly (1) from injection actuation pressure sensor (2).
- Remove injection actuation pressure sensor (2).
Show/hide table
| |
| Illustration 1 | g01104240 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install injection actuation pressure sensor (2). Tighten the injection actuation pressure sensor to a torque of
20 ± 2 N·m (15 ± 1 lb ft) . - Connect harness assembly (1) to injection actuation pressure sensor (2).
Show/hide table
|
| |
| Illustration 2 | g01104240 |
Caterpillar Information System:
3406E Marine Engine Engine Oil Cooler - Remove
3408E and 3412E Engines for Caterpillar Built Machines Poor Acceleration or Response
C11 and C13 Engines for Caterpillar Built Machines Low Power/Poor or No Response to Throttle
3126B and 3126E On-highway Engines Coolant Temperature Sensor - Remove and Install
PM3500 Power Modules Voltage Regulators
3406E Marine Engine Water Temperature Regulator - Remove and Install
PM3500 Power Modules Parallel Operation
3126B and 3126E On-highway Engines Fast Idle Enable Circuit - Test
2001/03/01 The Booklet, SENR9620, "Improving Fuel System Durability" Is Available {1250}
3406E and C15 Marine Engines Electronic Control Module - Remove and Install
3406E Marine Engine Fuel Transfer Pump - Install
3406E and C15 Marine Engines Fuel Transfer Pump - Remove
C-9 Engines for Caterpillar Built Machines Fuel System
3406E and C15 Marine Engines Engine Oil Cooler - Install
3126B and 3126E On-highway Engines Engine Oil Pressure Sensor - Remove and Install
3126B and 3126E On-highway Engines Wait To Start Lamp Circuit - Test
PM3516 Power Modules Fuel Transfer System - Prime
C-9 Engines for Caterpillar Built Machines Lubrication System
2001/02/01 Corrections to Operation and Maintenance Manual, SEBU7252-03, "3500B High Displacement Generator Set Engines" {1000, 1900, 7500, 7595, 7595}
2001/02/19 The Booklet, SENR9620, "Improving Fuel System Durability" Is Available {1250}
3406E and C15 Marine Engines Engine Oil Cooler - Disassemble
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Speed/Timing Sensor - Calibrate
3126B and 3126E On-highway Engines Service Brake Pedal Position (Switch 2) Circuit - Test
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Electronic Display Module