Coolant Temperature Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect harness assembly (2) from coolant temperature sensor (1).
- Remove coolant temperature sensor (1).
Show/hide table
Illustration 1 | g01104203 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install coolant temperature sensor (1). Tighten the coolant temperature sensor to a torque of
20 ± 3 N·m (15 ± 3 lb ft) . - Connect harness assembly (2) to coolant temperature sensor (1).
Show/hide table
Illustration 2 | g01104203 |
Caterpillar Information System:
PM3500 Power Modules Voltage Regulators
3406E Marine Engine Water Temperature Regulator - Remove and Install
PM3500 Power Modules Parallel Operation
3126B and 3126E On-highway Engines Fast Idle Enable Circuit - Test
2001/03/01 The Booklet, SENR9620, "Improving Fuel System Durability" Is Available {1250}
3406E and C15 Marine Engines Electronic Control Module - Remove and Install
3406E Marine Engine Fuel Transfer Pump - Install
3406E and C15 Marine Engines Fuel Transfer Pump - Remove
3524B Engines for 797 and 797B Off-Highway Trucks Flywheel - Inspect
795F and 795F Series AC Off-Highway Truck Power Train Final Drive, Brake and Wheel (Rear) - Disassemble
3406E and C15 Marine Engines Fuel Filter Base - Remove and Install
3406E Marine Engine Fuel Priming Pump - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Low Power/Poor or No Response to Throttle
3408E and 3412E Engines for Caterpillar Built Machines Poor Acceleration or Response
3406E Marine Engine Engine Oil Cooler - Remove
3126B and 3126E On-highway Engines Injection Actuation Pressure Sensor - Remove and Install
C-9 Engines for Caterpillar Built Machines Fuel System
3406E and C15 Marine Engines Engine Oil Cooler - Install
3126B and 3126E On-highway Engines Engine Oil Pressure Sensor - Remove and Install
3126B and 3126E On-highway Engines Wait To Start Lamp Circuit - Test
PM3516 Power Modules Fuel Transfer System - Prime
C-9 Engines for Caterpillar Built Machines Lubrication System
2001/02/01 Corrections to Operation and Maintenance Manual, SEBU7252-03, "3500B High Displacement Generator Set Engines" {1000, 1900, 7500, 7595, 7595}
2001/02/19 The Booklet, SENR9620, "Improving Fuel System Durability" Is Available {1250}