Cylinder Liner - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1A-1460     | Bolt     | 3     |
2J-3507 | Full Nut     | 1     | |
5F-7347 | Head     | 1     | |
5H-1504 | Hard Washer     | 1     | |
5P-8245 | Washer     | 3     | |
6V-2183 | Screw     | 1     | |
8H-0684 | Ratchet Wrench     | 1     | |
9U-6234 | Puller Plate     | 1     | |
9U-6281 | Leg     | 3     |
Start By:
- Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove".
- Remove the pistons and connecting rods. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Remove".
- Remove the piston cooling jets. Refer to Disassembly and Assembly, "Piston Cooling Jets - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Before you proceed with the removal of the cylinder liner, check the cylinder liners for wear or for damage. Check the inner diameter of each cylinder liner at the top, the middle, and the bottom. Check the inner diameter at two places that are 180 degrees away from each other. The maximum wear for the cylinder liners is 0.25 mm (.010 inch).
Note: An engine may have a high rate of oil consumption if the surface of the cylinder liners are glazed. Glaze can be removed from the cylinder liners by honing the bore of the cylinder liner.
- Rotate the crankshaft in order to gain access to the cylinder liner. Place a protective cover on the crankshaft in order to prevent damage.
- Install Tool (A) . Refer to Illustration 1.
Show/hide table
Illustration 1 | g00635284 |
- Remove cylinder liner (1) .
Caterpillar Information System:
322C Excavator Machine System Specifications Track
3126B Engines Basic Engine
C-15 and C-16 Industrial Engines Reference Material
3054 Engine Cylinder Liner Projection - Inspect
3054 and 3056 Marine Generator Set Engines Cooling System - Test
3054 and 3056 Marine Generator Set Engines Cooling System - Inspect
3126B Industrial Engine Turbocharger - Remove
3054 and 3056 Marine Generator Set Engines Cooling System - Check - Overheating
2000/12/01 Recommended Procedure For Lubricating And Tightening The Bolts That Fasten The Counterweights To The Crankshaft {1231}
3054 Engine Engine Oil Pressure - Test
C-15 and C-16 Industrial Engines Sensors and Electrical Components
G3516B and G3520B Generator Set Engines Engine Oil Cooler - Remove
3054 and 3056 Marine Generator Set Engines Cylinder Liner - Install
Marine Monitoring System II Analog Input Module
G3516B and G3520B Generator Set Engines Engine Oil Cooler - Install
3054 Engine Connecting Rod - Inspect
3126E and 3126B Commercial and Truck Engines Engine Storage Procedure - Check
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Prelubrication System
Marine Monitoring System II Related Components
3054 Engine Flywheel Housing - Inspect
3054 Engine Flywheel - Inspect
2001/10/01 A New Configuration of Valve Springs Is Now In Production {1108}
3064 and 3066 Engines for Caterpillar Built Machines Engine Oil Pressure Switch
3054 Engine Alternator - Test