Water Pump - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position water pump (4). Install bolts (5) .
Show/hide table
 | |
| Illustration 1 | g01026819 |
- Connect hose assembly (2) .
- Connect hose (3) .
- Install water pump V-belt (1) .
- Fill the cooling system with coolant to the correct level. Refer to the Operation and Maintenance Manual, "Cooling System Coolant - Change".
Caterpillar Information System:
3126B Industrial Engine Engine Oil Pressure Sensor - Test
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Speed/Timing Sensor
3054 Engine Cylinder Head - Inspect
C32 Petroleum Engines Diagnostic Flash Code Retrieval
3054, 3054B and 3056 Marine Engines Engine Valve Lash - Inspect/Adjust
3126B Industrial Engine Water Pump - Assemble
C-10 and C-12 Industrial Engines Lubrication System
C-15 and C-16 Industrial Engines Water Lines
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Sensor Open/Short Test
C-10 and C-12 Industrial Engines Air Inlet and Exhaust System
3126B Industrial Engine Vibration Damper and Pulley - Remove and Install
3126B Industrial Engine Belt Tightener - Remove
3054 Engine Engine Oil Pump - Inspect
3126B Industrial Engine Vibration Damper
C4.4 Industrial Engine Fuel Conservation Practices
3126B Industrial Engine Turbocharger - Install
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Injector Solenoids
G3516B and G3520B Generator Set Engines Engine Oil Cooler - Remove
C-15 and C-16 Industrial Engines Sensors and Electrical Components
3054 Engine Engine Oil Pressure - Test
2000/12/01 Recommended Procedure For Lubricating And Tightening The Bolts That Fasten The Counterweights To The Crankshaft {1231}
3054 and 3056 Marine Generator Set Engines Cooling System - Check - Overheating
3126B Industrial Engine Turbocharger - Remove
3054 and 3056 Marine Generator Set Engines Cooling System - Inspect