Water Pump - Assemble
Assembly Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
B     | 5P-9722     | Seal Driver     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install the shaft and the bearing into pulley (5) with a press. Install the shaft until the shaft is flush with the end of pulley (5) .
Show/hide table
Illustration 1 | g01026872 |
- Press the shaft, the bearing, and pulley (5) as a unit into water pump housing (4). The distance between the front of pulley (5) and the machined surface of water pump housing (4) must be 103.8 ± 0.3 mm (4.09 ± 0.01 inch).
- Install seal (3) in water pump housing (4) with Tooling (B) .
- Install impeller (2) on the shaft of the water pump with a press. Install the impeller until the distance between the impeller and the machined surface of the water pump is 0.75 ± 0.25 mm (0.030 ± 0.010 inch).
Show/hide table
Illustration 2 | g01026894 |
Typical example |
- Install a new gasket and cover (1) .
Show/hide table
Illustration 3 | g01026865 |
End By: Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".
Caterpillar Information System:
C-10 and C-12 Industrial Engines Lubrication System
C-15 and C-16 Industrial Engines Water Lines
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Sensor Open/Short Test
C-10 and C-12 Industrial Engines Air Inlet and Exhaust System
3126B Industrial Engine Vibration Damper and Pulley - Remove and Install
3126B Industrial Engine Belt Tightener - Remove
3126B Industrial Engine Belt Tightener - Install
3126B Industrial Engine Engine Oil Pan - Remove and Install
3126B Industrial Engine Air Inlet Heater - Remove and Install
3126B Industrial Engine Fuel Filter Base - Remove and Install
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Emergency Stop Switch
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets ECM/Personality Module
3054, 3054B and 3056 Marine Engines Engine Valve Lash - Inspect/Adjust
C32 Petroleum Engines Diagnostic Flash Code Retrieval
3054 Engine Cylinder Head - Inspect
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Engine Speed/Timing Sensor
3126B Industrial Engine Engine Oil Pressure Sensor - Test
3126B Industrial Engine Water Pump - Install
3054 Engine Engine Oil Pump - Inspect
3126B Industrial Engine Vibration Damper
C4.4 Industrial Engine Fuel Conservation Practices
3126B Industrial Engine Turbocharger - Install
3500B and 3500B High Displacement Engines for Caterpillar Built Generator Sets Injector Solenoids
G3516B and G3520B Generator Set Engines Engine Oil Cooler - Remove