G3304 and G3306 Engines Caterpillar


Engine Oil Pressure is High

Usage:

G3306 07Y
下述情况会造成发动机机油压力高:

  • 发动机机油油位太高。 放掉多余的发动机机油。

  • 发动机机油温度太低。 发动机机油温度低提高了发动机机油的粘度。

  • 发动机机油滤清器旁通阀卡在关闭位置。 彻底清洁此阀。 更换发动机机油滤清器。

  • 某一发动机机油油管或油道阻塞。 清洁该部件。

Caterpillar Information System:

Electronic Modular Control Panel II (EMCP II) Fault Log Viewing OP1
3500B Marine Engines Secondary ECM Assumes Control
3126B and 3126E On-highway Engines Ignition Keyswitch Circuit and Battery Supply Circuit - Test
C-10, C-12, C-15 and C-16 Industrial Engines Air Shutoff System - Test
C-10, C-12, C-15 and C-16 Industrial Engines PTO Ramp Up/Down Switch Circuit - Test
C-9 Industrial Engine E095 Fuel Filter Restriction Warning
Electronic Modular Control Panel II (EMCP II) Electronic Control Module (Engine) - EUI Engines Only
Electronic Modular Control Panel II (EMCP II) Diagnostic Codes
Electronic Modular Control Panel II (EMCP II) Customer Interface Module
Electronic Modular Control Panel II (EMCP II) Shutdown Mode - For PEEC and EUI Engines
Electronic Modular Control Panel II (EMCP II) Shutdown Mode - For MUI Engines
Electronic Modular Control Panel II (EMCP II) Alarm Mode
G3304 and G3306 Engines Engine Oil Pressure is Low
G3406 Engine Measuring Engine Oil Pressure
Electronic Modular Control Panel II (EMCP II) Relay Driver Module
Electronic Modular Control Panel II (EMCP II) System Communication Module (Customer)
G3304 and G3306 Engines General Information (Lubrication System)
Electronic Modular Control Panel II (EMCP II) Starting Motor Remains Engaged (for EUI and PEEC Engines)
G3304 and G3306 Engines General Information (Cooling System)
Electronic Modular Control Panel II (EMCP II) Starting Motor Remains Engaged (for MUI 3412C, 3508, 3512, 3516 Engines)
Electronic Modular Control Panel II (EMCP II) Engine Does Not Shutdown (for EUI Engines)
Electronic Modular Control Panel II (EMCP II) Engine Does Not Shutdown (for MUI 3306B, 3406C Engines)
Electronic Modular Control Panel II (EMCP II) Engine Does Not Shutdown (for MUI 3412C, 3508,3512, 3516 Engines)
Electronic Modular Control Panel II (EMCP II) AC Offset Adjustment OP10
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.