0164-00 Excessive Injection Actuation Pressure (17)
Conditions Which Generate This Code:
The ECM detected the following conditions:
- The injection actuation pressure is greater than 26.5 MPa (3844 psi) for more than six seconds.
- Engine speed is greater than 0 MPH.
- Engine coolant temperature is more than 18 °C (64 °F).
- The ECM has been powered for at least three seconds.
- Cold Mode is not active.
Note: The diagnostic code indicates a mechanical problem. The ECM and the electronic control system is operating correctly.
System Response:
"0%"will be displayed next to "Injector Output %" on the status screen.
The check engine lamp will illuminate.
The ECM limits power output to 89.5 kW (120.0 hp) and the vehicle speed is limited to 73 km/h (45 mph).
The engine may emit white smoke at start-up because Cold Mode is not active.
Note: The problem may only exist at operating temperature.
Test Step 1. Perform the following diagnostic procedure: Injection Actuation Pressure - Test
Results:
- OK - STOP
Caterpillar Information System:
3126B and 3126E On-highway Engines 0102-07 Boost Pressure not responding
3126B and 3126E On-highway Engines 0070-06 Inlet Air Heater current high
320B, 320B L and 320B N Excavators Joystick Controls
3126B and 3126E On-highway Engines 0070-05 Inlet Air Heater current low
3126B and 3126E On-highway Engines 0064-11 Secondary Engine Speed no pattern (34)
3126B and 3126E On-highway Engines 0064-02 Secondary Engine Speed loss of signal (34)
3126B and 3126E On-highway Engines 0247-11 Brake Pedal Switch #2 Fault
3126B and 3126E On-highway Engines 0246-11 Brake Pedal Switch #1 Fault
3126B and 3126E On-highway Engines 0110-11 Very High Coolant Temperature (61)
3126B and 3126E On-highway Engines 0110-00 High Coolant Temperature Warning (61)
Oil Mist Detectors Maintenance Schedule
3618 Engine Fuel Injector Synchronization
3126B and 3126E On-highway Engines 0164-02 Injection Actuation Pressure Signal Erratic (15)
3126B and 3126E On-highway Engines 0164-03 Injection Actuation Pressure voltage high (15)
3126B and 3126E On-highway Engines 0164-04 Injection Actuation Pressure voltage low (15)
3126B and 3126E On-highway Engines 0164-11 Injection Actuation Pressure system fault (39)
3406E, C-10 and C-12 Truck Engines Compression Brake
3126B and 3126E On-highway Engines 0190-11 Primary Engine Speed no pattern (34)
JF Series Starting Motor General Information
3126B and 3126E On-highway Engines 0253-14 Truck Manufacturer Parameter Not Programed
3126B and 3126E On-highway Engines 0190-02 Primary Engine Speed Loss of Signal (34)
CPT372 Truck Mounted Pumper Reference Information
3126B Engine for Caterpillar Built Machines CID 0091 FMI 08 Throttle Position signal abnormal
2000/08/01 Additional Serviceable Components Are Available For The Caterpillar Ignition System (CIS) {1550}