Brush Length - Check
Show/hide table
Illustration 1 | g00720873 |
Brush holder (1) Brushes (2) Brush length |
- Measure the length of brushes (1). The minimum brush length (2) is 7.6 mm (0.30 inch). New brush length (2) is 21.9 mm (0.86 inch).
- Replace the brush holder if the brush length (2) is near the minimum length.
Caterpillar Information System:
JF Series Starting Motor Starting Motor Does Not Turn or Turns Slowly
G3516B Engines Oxygen Sensor Signal
3306C Truck Engine Engine Oil Pressure - Test
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0445 - FMI 12 (for PEEC Engines)
3306C Truck Engine Engine Valve Lash - Inspect/Adjust
3306C Truck Engine Compression - Test
3306C Truck Engine Engine Crankcase Pressure (Blowby) - Test
3306C Truck Engine Aftercooler - Test
3306C Truck Engine Exhaust Temperature - Test
3306C Truck Engine Inlet Manifold Pressure - Test
Electronic Modular Control Panel II+ (EMCP II+) GSC CID 0445 - FMI 12 (for MUI Engines)
3306C Truck Engine Turbocharger - Inspect
JF Series Starting Motor Starting Motor - Disassemble
3500B Engines for Caterpillar Built Power Modules General Information
3306C Truck Engine Vibration Damper - Check
3306C Truck Engine Flywheel Housing - Inspect
3306C Truck Engine Flywheel - Inspect
3306C Truck Engine Cylinder Block - Inspect
3306C Truck Engine Cylinder Liner Projection - Inspect
3306C Truck Engine Main Bearings - Inspect
Alternator - Delco 21SI Field Winding - Test
EMCP3 General Information
Electronic Modular Control Panel II (EMCP II) Service Tools
Electronic Modular Control Panel II+ (EMCP II+) Fault Identification