MID 036 - CID 0444 - FMI 06 Start Relay short to ground
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects excessive current for the output of the starting motor relay.
Note: This diagnostic condition can only be detected by the ECM when the output for the starting motor relay is ON. The output is normally ON when the engine control is changed from the STOP mode to the START mode. The output is ON until the crank terminate relay is energized.
System Response:
The ECM will continue to attempt to energize the relay. The alarm output is activated. The code is logged.
Possible Performance Effect:
The engine will probably be unable to crank.
Troubleshooting:
Test Step 1. Perform the following diagnostic procedure: "ECM Output Circuit (Starting Motor)"
Results:
- OK - STOP
Caterpillar Information System:
3408E and 3412E Industrial Engines Turbocharger Oil Lines
G3300 Engines General Hazard Information
3114, 3116, and 3126 Engines Air Inlet and Exhaust System - Inspect
G3408 and G3412 Engines Alarms and Shutoffs
G3516B Engines MID 036 - CID 0444 - FMI 05 Start Relay open circuit
3034 Engine for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
3612 and 3616 Engines Engine Barring Group
3408E and 3412E Engines for Caterpillar Built Machines E164 High Injector Actuation Pressure
2000/05/01 Corrections To Specifications Modules, G3600 Engines , "Piston and Rings" {1214, 1215}
Alternator - Delco 21SI Capacitor - Test
325, 325B and 325L Excavators Swing Gear and Bearing - Install
325, 325B and 325L Excavators Swing Gear and Bearing - Remove
G3516B Engines MID 036 - CID 0445 - FMI 03 Run Relay short to +batt
G3516B Engines MID 036 - CID 0524 - FMI 04 Desired Engine Speed Sensor short to ground
G3516B Engines MID 036 - CID 0524 - FMI 03 Desired Engine Speed Sensor short to +batt
3064 and 3066 Engines for Caterpillar Built Machines Fuel System - Inspect
G3516B Engines MID 036 - CID 0542 - FMI 03 Unfiltered Engine Oil Pressure open/short to +batt
G3516B Engines MID 036 - CID 0542 - FMI 04 Unfiltered Engine Oil Pressure short to ground
G3516B Engines MID 036 - CID 1042 - FMI 09 Unable to communicate with ITSM
G3516B Engines MID 036 - CID 1086 - FMI 09 Oxygen Sensor Element not communicating on link
3412 Generator Set Engines Turbocharger Outlet Pressure Sensor
3412 Generator Set Engines Magnetic Switch
3114, 3116, and 3126 Engines Turbocharger - Inspect
3034 Engine for Caterpillar Built Machines Fuel Injection Nozzle - Test