Capacitor - Test
Show/hide table
Illustration 1 | g00708845 |
(1) Capacitor (2) Capacitor terminals |
- Remove capacitor (1) from the alternator.
- Connect the terminals (2) of the capacitor together with a jumper wire. This discharges the capacitor.
Note: The capacitor (1) must be discharged after step 3 is completed.
- Set the multimeter to the "20M ohm" resistance scale. Connect the multimeter leads to the capacitor terminals (2) .
- The multimeter reading should indicate very low resistance for a short period of time. The multimeter reading should then stabilize above 100 k Ohms(0.100 M Ohms).
- If the multimeter reading is not within the tolerance, replace the capacitor.
Caterpillar Information System:
325, 325B and 325L Excavators Swing Gear and Bearing - Install
325, 325B and 325L Excavators Swing Gear and Bearing - Remove
325, 325B and 325L Excavators Swivel - Install
325, 325B and 325L Excavators Swivel - Assemble
325, 325B and 325L Excavators Swivel - Disassemble
325, 325B and 325L Excavators Swivel - Remove
HDB Series and M1 Series Heavy Duty Brushless Alternators Service Tools
325, 325B and 325L Excavators Final Drive - Install
325, 325B and 325L Excavators Final Drive - Assemble
325, 325B and 325L Excavators Final Drive - Disassemble
325, 325B and 325L Excavators Final Drive - Remove
325, 325B and 325L Excavators Travel Motor - Install
2000/05/01 Corrections To Specifications Modules, G3600 Engines , "Piston and Rings" {1214, 1215}
3408E and 3412E Engines for Caterpillar Built Machines E164 High Injector Actuation Pressure
3612 and 3616 Engines Engine Barring Group
3034 Engine for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
G3516B Engines MID 036 - CID 0444 - FMI 05 Start Relay open circuit
G3408 and G3412 Engines Alarms and Shutoffs
3114, 3116, and 3126 Engines Air Inlet and Exhaust System - Inspect
G3300 Engines General Hazard Information
3408E and 3412E Industrial Engines Turbocharger Oil Lines
G3516B Engines MID 036 - CID 0444 - FMI 06 Start Relay short to ground
G3516B Engines MID 036 - CID 0445 - FMI 03 Run Relay short to +batt
G3516B Engines MID 036 - CID 0524 - FMI 04 Desired Engine Speed Sensor short to ground