Camshaft - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Slide camshaft assembly (1) into the cylinder block.
Show/hide table
 | |
| Illustration 1 | g00701151 |
- Align the timing marks on idler gear (2) and on the camshaft gear (3) .
Show/hide table
 | |
| Illustration 2 | g00701149 |
- Install bolts (4) that secure the camshaft assembly to the cylinder block.
- Tighten bolts (4) to 9 N·m (80 lb in).
End By:
- Install the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Install".
- Install the lifters. Refer to Disassembly and Assembly, "Lifter Group - Remove and Install".
- Install the rocker shaft assembly and pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrods - Install ".
Caterpillar Information System:
G3516B Engines +5V Sensor Voltage Supply
3126B Marine Engine Aftercooler Condensate Drain Valve - Inspect/Clean
2000/04/01 Revised Troubleshooting Module Available {1000}
3034 Engine for Caterpillar Built Machines Camshaft - Remove
2000/12/01 A New Electronic Actuator Is Used In Gas Pressure Regulator Groups That Are On Engines That Have Air/Fuel Ratio Control Systems {1716}
G3406 Engine Safety Messages
G3408 and G3412 Engines Model View Illustrations
G3516B Engines Engine Starts but Stalls Immediately
G3516B Engines Event Codes
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>115-5101</B> Generator through <B>121-6860</B> Generator
3114, 3116, and 3126 Engines Fuel Ratio Control - Adjust
3126B Marine Engine Diagnostic Lamp
3114, 3116, and 3126 Engines Fuel System - Prime
3618 Engine Annunciator Panel - Inspect
3034 Engine for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
G3408 and G3412 Engines Gauges and Indicators
3114, 3116, and 3126 Engines Fuel System Pressure - Test
3176C and 3196 Engines for Caterpillar Built Machines Camshaft
G3406 Engine Model View Illustrations
3034 Engine for Caterpillar Built Machines Fan - Remove and Install
3114, 3116, and 3126 Engines Fuel Timing Dimension - Adjust
3034 Engine for Caterpillar Built Machines Crankshaft Gear - Remove and Install
584 and 584HD Forwarders General Hazard Information
325, 325B and 325L Excavators Part Number Location