Electronic Unit Injector Sleeve - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A (1)     | 9U-7259     | Puller Stud     | 1     |
128-7889 | Bridge Puller     | 1     | |
9U-6877 | Thrust Bearing     | 1     | |
5P-8247 | Hard Washer     | 1     | |
4K-0367 | Nut     | 1     |
Show/hide table
( 1 ) | The tools that are listed in the chart are part of the 9U-6891 Injector Tool Group . |
Start By:
- Remove the electronic unit injectors.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install the puller stud from Tool (A) into the unit injector sleeve.
Show/hide table
Illustration 1 | g00512128 |
Typical example |
- Install the following parts from Tool (A) over the stud: bridge puller, thrust bearing, hard washer and nut. See Step 1.
Show/hide table
Illustration 2 | g00512002 |
- Tighten the nut until the unit injector sleeve is pulled free of the cylinder head assembly.
- Remove Tool (A) from the unit injector sleeve.
- Repeat Steps 1 through 4 in order to remove the remaining unit injector sleeves.
Caterpillar Information System:
3176C and 3196 Marine Engines Electronic Unit Injector - Install
723PLUS Digital Speed Control Watch Window PC Interface
723PLUS Digital Speed Control Programmable Parameters
3176C and 3196 Marine Engines Electronic Unit Injector - Remove
2000/02/01 New Oil Filter Base Group {1306}
3176C and 3196 Marine Engines Fuel Transfer Pump - Remove and Install
723PLUS Digital Speed Control Installation Checkout Procedure
2000/02/01 Throttle Synchronization Wiring for Electronic Marine Engines {1900}
2000/02/01 Software Part Number Reference in TMI {7620}
2000/02/01 New Software for 3412C PEEC III Engines {7620}
3176C and 3196 Marine Engines Fuel Filter Base - Remove and Install
2000/02/01 New Alternator Mounting Bracket Now Used {1405}
3608 Engine Sea Water Cooling System Operation
3500B Engines Cylinder Head
3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Test
3608 Engine Fuel System Operation
Electronic Modular Control Panel II+ (EMCP II+) Normal Mode
2000/02/07 New Oil Filter Base Group {1306}
3500B Engines for Caterpillar Built Power Modules Test for the Water Temperature Regulator
3176C and 3196 Marine Engines Turbocharger - Remove
2000/01/01 Correction to Specifications Module, SENR5117-03, "3116 Diesel Truck Engine" {1201}
3500 Generator Set Engines Auxiliary Drive Pulley
2000/01/17 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901} Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901}