3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader Caterpillar


CID 0174 FMI 04 Fuel Temperature short to ground

Usage:

988G 2TW
Conditions Which Generate This Code:

The Electronic Control Module (ECM) detects the following conditions:

  • The ECM reads signal voltage that is below 0.2 VDC for one second.

  • The ECM has been powered for at least three seconds.

System Response:

The ECM will log the diagnostic code. The ECM flags fuel temperature as invalid data and a default value of 30 °C (86 °F) is used.

Possible Performance Effect:

  • Low power

Troubleshooting:

Test Step 1.

Results:

  • OK - STOP

Caterpillar Information System:

3114, 3116 and 3126 MUI Engine Governors Throttle Lever (Types IV, V, VI, VII, and Some III) - Install
Uninterruptible Power Supply (UPS) 250 Contactor - Remove and Install
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Flywheel Inverter Module - Remove and Install
2000/02/01 New Oil Filter Base Group {1306}
723PLUS Digital Speed Control Accessories
3176C and 3196 Engines for Caterpillar Built Machines CID 0168 FMI 00 System Voltage High
3176C and 3196 Engines for Caterpillar Built Machines CID 0168 FMI 01 System Voltage Low
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0168 FMI 02 System Voltage intermittent/erratic
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0174 FMI 03 Fuel Temperature open/short to +batt
3408E and 3412E Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
2000/01/01 Corrections to Operation and Maintenance Manual, SEBU6759-02 , "Maintenance Interval Schedule" and Corrections to Operation and Maintenance Manual, SEBU6759-02 , "Maintenance Recommendations" {7519}
3408E and 3412E Engines for Caterpillar Built Machines CID 0164 FMI 03 Injector Actuation Pressure voltage high
3408E and 3412E Engines for Caterpillar Built Machines CID 0175 FMI 03 Engine Oil Temperature open/short to +batt
3408E and 3412E Engines for Caterpillar Built Machines CID 0175 FMI 04 Engine Oil Temperature short to ground
Uninterruptible Power Supply (UPS) 250 Fuse - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines CID 0190 FMI 03 Engine Speed open/short to + batt
3126B and 3126E On-highway Engines Camshaft - Install
3500B and 3500B High Displacement Generator Set Engines Crankshaft
3500B and 3500B High Displacement Generator Set Engines Camshaft
3516B Generator Set Engines with Dynamic Gas Blending Electrical System Operation
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0190 FMI 02 Loss of Engine Speed Signal
723PLUS Digital Speed Control Electrostatic Discharge Awareness
3408E and 3412E Engines for Caterpillar Built Machines CID 0190 FMI 07 Primary Speed Sensor misinstalled
3408E and 3412E Engines for Caterpillar Built Machines CID 0190 FMI 08 Engine Speed signal abnormal
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.