Declaration of Incorporation
In accordance with "EMC Directive 89/336/EEC" and with the amendments of the directive, this controlling device is applied solely as a component for a prime mover system that is driven by an engine. This controlling device complies with the requirements of "EN50081-2" and "EN50082-2" when the device is put into service per the instructions for installation and operation. The instructions are outlined in the manual for the product.
Note: This controlling device is intended only for use in a prime mover system under the following conditions:
- The system meets the requirements of the above Directive.
- The system bears the CE mark.
Caterpillar Information System:
723PLUS Digital Speed Control Introduction
3114, 3116 and 3126 MUI Engine Governors Governor (Type VI) - Adjust
3126B Engines for Caterpillar Built Machines Unit Injector - Install
3500 Industrial Engines Cylinder Block
G3500B Engines Measuring Engine Oil Pressure
3500 Engines For Caterpillar Built Power Modules General Information (Lubrication System)
3406E and C15 Marine Engines Turbocharger - Disassemble
G3520B Industrial Engines Camshaft Timing
2000/01/01 New Electronic Control (Detonation Mixing Control Module) Eliminates Erroneous Shutdown Codes {1901}
2000/01/01 New Basic Cylinder Head Groups Include Premachined Valve Seat Inserts For Improved Reliability {1100}
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application Remote PTO Accelerator Position Sensor Circuit - Test
G3500 Engines Valve Lash and Valve Bridge Adjustment
G3304 and G3306 Engines Test Tools for the Electrical System
723PLUS Digital Speed Control Application
3512 Industrial Engine Flywheel
3176C Industrial Engine Fan Drive - Remove
3176C Industrial Engine Fan Drive - Install
2000/01/01 New Shafts In Water Pump Groups Provide Increased Torsional Strength {1361, 1389}
3306B Industrial Engine Maintenance Interval Schedule
3114, 3116 and 3126 MUI Engine Governors Throttle Lever (Types IV, V, VI, VII, and Some III) - Remove
3176C Engine Maintenance Interval Schedule
723PLUS Digital Speed Control Control Options
3456 Engine, 836G Landfill Compactor, 834G Wheel Dozer and 988G Wheel Loader CID 0100 FMI 13 Engine Oil Pressure calibration required
2000/01/01 Cooling System Venting Procedure {1350}