30SI Series and 34SI Series Alternator Caterpillar


T4 Alternator Drive System - Check

Usage:

769C 01X

  • Check the condition of the alternator drive belt. If the drive belt is oily, clean the pulleys. Replace the drive belt, and retest the system. If the drive belt is wet, dry the belt and retest the system. If the drive belt is worn, replace the belt and retest the system.

    1. Check the tension of the alternator drive belt. If the tension is off, adjust the tension.

    1. Check the nut on the alternator pulley. If the nut is loose, tighten the nut and retest the system.

    1. If all of the previous steps find no problems go to Testing and Adjusting, "T3 Charging System - Test".
  • Caterpillar Information System:

    30SI Series and 34SI Series Alternator T3 Charging System - Test
    3406E and 3456 Generator Set Engines Fuel Quality - Test
    30SI Series and 34SI Series Alternator T2 Electrical System Current - Test
    30SI Series and 34SI Series Alternator T1 Alternator Output - Test
    3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders MID 036 - CID 0277 - FMI 08 Timing Calibration signal abnormal
    3126B Engine for Caterpillar Built Machines Engine Will Not Crank
    3054B Industrial Engine Gear Group (Front) - Install
    3054B Industrial Engine Gear Group (Front) - Remove
    C-9 Engines for Caterpillar Built Machines Pinion Clearance - Adjust
    3406E and 3456 Engines for Caterpillar Built Machines Troubleshooting
    3618 Engine Engine Oil Level Switch - Remove and Install
    Customer Communication Module (CCM) for Diesel Engines Data Link Guidelines
    30SI Series and 34SI Series Alternator T5 Alternator Current - Test
    30SI Series and 34SI Series Alternator T6 Residual Magnetism Restoration
    30SI Series and 34SI Series Alternator T7 Identifying Source of Current Draw - Test
    30SI Series and 34SI Series Alternator T8 Alternator Overcharging - Test
    C-12, C-15 and C-16 Engines for Caterpillar Built Machines Alternator - Charging Problem
    3306B Generator Set Generator Set Installation
    Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines CID 168 FMI 4 Electrical System Voltage Below Normal - Test
    C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Coolant in Engine Oil
    Air Conditioning and Heating R134a for All Caterpillar Machines Refrigerant Condenser
    3126B Marine Engine Coolant Level Sensor - If Equipped
    3126B Marine Engine Engine Oil Pressure Sensor
    3406E and 3456 Generator Set Engines Turbocharger - Inspect
    Back to top
    The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
    CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.