Starting Motor Magnetic Switch - Test
Show/hide table
 | |
| Illustration 1 | g00289497 |
Speed Sensor (1) Speed sensor (2) Locknut (A) Air gap | |
This adjustment procedure is for the engine speed sensor.
- Remove the speed sensor (1) from the flywheel housing. Remove all debris from the tip of the speed sensor. Align a ring gear tooth directly in the center of the threaded sensor opening.
- By hand, screw the speed sensor (1) into the hole until the end of the sensor contacts the gear tooth.
- Turn the sensor (1) in the counterclockwise direction through 270 degrees (three-fourths turn).
- Tighten locknut (2) to 25 ± 5 N·m (18 ± 4 lb ft).
Note: Do not allow speed sensor (1) to turn as locknut (2) is tightened.
Caterpillar Information System:
C9 Engines for Caterpillar Built Machines Unit Injector Sleeve - Install
3500 Engines for Caterpillar Built Generator Sets Fuel Pressure Regulator
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Speed Sensor (Engine) - Adjust
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Alarm Module Control - Adjust
G3304 and G3306 Engines Governor Linkage
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines AC Voltage Range - Adjust
G3304 and G3306 Engines Governor Linkage - Woodward PSG Governor For Turbocharged Engines
C-9 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
C9 Engines for Caterpillar Built Machines Unit Injector Sleeve - Remove
3126 Truck Engine Military Engine Lifting Bracket - Remove and Install
SR4 and SR4B Generators and Control Panels Electromechanical Control Panel with Automatic Start/Stop
3126B and 3126E On-highway Engines Factory Passwords Worksheet
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Pulse Width Modulated (PWM) Sensor - Test
3612 and 3616 Engines Engine Oil Filter Housings - Remove
3406E On-Highway Engine Exhaust Manifold - Remove and Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Block Diagram of Generator Set Control
C9 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
3612 and 3616 Engines Engine Oil Filter Housings - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines EMCP Electronic Control (AC Transformer Box) - Replace
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Relay Module - Replace
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines EMCP Electronic Control (Generator Set) - Replace
SR500 Generators Bearing (Spherical Roller) - Lubricate
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Typical Generator Abbreviations
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Symbols