G3304 and G3306 Engines Caterpillar


Governor Linkage

Usage:

G3306 07Y



Illustration 1g00632349

Position (A) is the FULL LOAD position. Position (B) is the SHUTOFF position.

Clamp carburetor lever (1) on the throttle shaft of the carburetor at the indicated angle when the throttle plate is closed. Install pin (2) in the shaft.

Caterpillar Information System:

Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines AC Voltage Range - Adjust
G3304 and G3306 Engines Governor Linkage - Woodward PSG Governor For Turbocharged Engines
C-9 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
C9 Engines for Caterpillar Built Machines Unit Injector Sleeve - Remove
3126 Truck Engine Military Engine Lifting Bracket - Remove and Install
SR4 and SR4B Generators and Control Panels Electromechanical Control Panel with Automatic Start/Stop
3126B and 3126E On-highway Engines Factory Passwords Worksheet
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines External Potential Transformer Connections
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Electrical Connector - Inspect
3512B Marine Auxiliary Engine Programmable System Parameters
3126 Truck Engine Military Injection Actuation Pressure Control Valve - Assemble
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Inaccurate Display of Voltage or Current or Power - Troubleshoot
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Alarm Module Control - Adjust
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Speed Sensor (Engine) - Adjust
3500 Engines for Caterpillar Built Generator Sets Fuel Pressure Regulator
C9 Engines for Caterpillar Built Machines Unit Injector Sleeve - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Starting Motor Magnetic Switch - Test
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Pulse Width Modulated (PWM) Sensor - Test
3612 and 3616 Engines Engine Oil Filter Housings - Remove
3406E On-Highway Engine Exhaust Manifold - Remove and Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines Block Diagram of Generator Set Control
C9 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
3612 and 3616 Engines Engine Oil Filter Housings - Install
Electronic Modular Control Panel II+ (EMCP II+) for EUI Engines EMCP Electronic Control (AC Transformer Box) - Replace
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.