G3500B Engines Caterpillar


Fuel System Fuel Filter Differential Pressure - Check

Usage:

G3516B 7EZ
必须安装燃料滤清器压差表,以便确定何时需要进行燃料滤清器的保养。 此仪表及燃气滤清器由用户提供。

燃气滤清器压差表指示燃气滤清器燃气进口侧和燃气出口侧之间的燃气差压。 当燃气滤清器堵塞时,差压会增加。

在额定转速和载荷下运转发动机。 检查燃气滤清器的差压。 当燃气滤清器的差压达到 1.7 kPa (0.25 psi)时要对其进行保养。

有关具体说明,请参阅专门说明书, SEHS9298, "气体燃料滤清器的安装和保养"。 请咨询您的卡特彼勒代理商以获得帮助。

Caterpillar Information System:

The Installation And The Alignment Of The Two-Bearing Locomotive Generators{4471} The Installation And The Alignment Of The Two-Bearing Locomotive Generators{4471}
3116 Truck Engine Engine Oil Level - Check
3116 Truck Engine Engine Crankcase Breather - Clean
3408E and 3412E Engines for Caterpillar Built Machines Electric Starting System - Test
G3606 and G3608 Engines Water Lines - Remove and Install
3054 Truck Engine Reference Material
G3500 Engines Flywheel Housing - Remove
G3606 and G3608 Engines Water Temperature Regulator and Housing - Remove
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Jacket Water Heater
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Travel Motor - Test
3126 Truck Engine (Military) Fuel Recommendations
G3500 Engines Crankshaft Front Seal and Wear Sleeve - Install
G3500B Engines Ignition System Spark Plugs - Inspect/Replace - Spark Plugs that have Precombustion Chambers
3612 and 3616 Engines Temperature Contactor
G3606 and G3608 Engines Crankcase Pressure Sensor - Remove and Install
3116 Truck Engine Engine Oil and Filter - Change
G3606 and G3608 Engines Fuel Shutoff Solenoid - Remove and Install
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Relief Valve (Travel Motor) - Test and Adjust
G3500 Engines Overhaul (In-Frame)
Electronic Modular Control Panel II+ (EMCP II+) Parallel Setpoint Viewing OP2-3
G3500 Engines Flywheel Housing - Install
G3500B Engines Overhaul (Major)
G3500B Engines Overhaul (Top End)
3116 Truck Engine Fuel Injection Timing - Check
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.