Illustration 1 | g00735635 |
Rotation of the pump is counterclockwise when the pump is viewed from the drive end.
Type of pump: Gear
Lubricate the pump with oil before you operate the pump.
Note: The pump must rotate freely by using your hand.
Bench test requirements: SAE 10W oil must be stabilized at
(1) Gear
(2) Clearance between a new gear and a new body ...
(3) Transmission scavenge section
- Output ...
855 L/min (225 US gpm) - Test pressure ...
70 kPa (10 psi) - Test speed for the pump ... 1800 rpm
- Test pressure ...
(4) Clearance between a new gear and a new cover ...
(5) Transmission charging section
- Output ...
295 L/min (78 US gpm) - Test pressure ...
3100 kPa (450 psi) - Test speed for the pump ... 1800 rpm
- Test pressure ...
(6) Keys
(7) Dimension of new shafts and of new pump bodies
- Diameter of the drive shafts and diameter of the driven shafts ...
50.795 ± 0.005 mm (1.9998 ± 0.0002 inch) - Diameter of the bearings in the pump body ...
50.851 ± 0.008 mm (2.0020 ± 0.0003 inch) - Diameter of the bearings in the pump body ...
Note: Make sure that gear (1) slides freely on two keys (6).
Illustration 2 | g00735054 |
(8) Measurement from end of the dowel to the face of the cover ...
(9) Location of the bearing joint from the vertical centerline ... 30 ± 15 degrees
(10) Depth of bearings into cover ...
Illustration 3 | g00735058 |
(11) Location of the bearing joint from the vertical centerline ... 30 ± 15 degrees
(12) Depth of two dampers (A) into body ...
(13) Depth of bearings into body ...
(14) Depth of four dampers (B) into body ...
Illustration 4 | g00735061 |
(15) Measurement from end of the dowel to the face of the body ...
Illustration 5 | g00735062 |
(16) Location of the bearing joint from the vertical centerline ... 30 ± 15 degrees
(17) Measurement from face of cover to face of sleeve ...
(18) Depth of bearings into cover ...