Crankshaft Pulley - Remove and Install
Removal Procedure
Start By:
- Remove the V-Belts. Refer to Disassembly and Assembly, "V-Belts - Remove and Install".
- Remove three bolts (2) that hold thrust block (3) in position.
Show/hide table
Illustration 1 | g00553762 |
Typical example |
- Remove thrust block (3) from the end of the crankshaft. The thrust block holds the crankshaft pulley in position on the end of the crankshaft.
- Remove crankshaft pulley (1) from the engine.
Note: Some engines have a water immersion seal that is placed on the front cover. The seal has a flexible lip on the front. The plastic mandrel that is supplied with the seal must be installed in the seal when the crankshaft pulley is removed. This will ensure that the lip maintains the correct shape.
Installation Procedure
- Remove the plastic mandrel, if necessary.
Show/hide table
Illustration 2 | g00553762 |
Typical example |
- Put crankshaft pulley (1) in position on the crankshaft.
- Apply 9S-3263 Thread Lock Compound to the threads of three bolts (2) .
- Put thrust block (3) in position and align the holes with the holes in the end of the crankshaft.
- Install three bolts (2) that hold the thrust block in position. Tighten bolts (2) to a torque of 115 N·m (85 lb ft).
Note: It may be necessary to keep the crankshaft from rotating while you torque bolts (3). Use the appropriate tools in order to keep the crankshaft from rotating.
End By: Install the V-Belts. Refer to Disassembly and Assembly, "V-Belts - Remove and Install".
Caterpillar Information System:
3608 Engine Engine Oil Pan - Disassemble
Generator Set Control Panel for Switchgear Conversion Tattletale Mode
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Install
3054 Engine for Caterpillar Built Machines Engine Oil Relief Valve - Remove and Install
G3606 and G3608 Engines Engine Oil Pan - Install
3412E and C30 Marine Engines Walk-Around Inspection
3054 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove
3054 and 3056 Industrial and Generator Set Engines Cylinder Head Valves
G3606 and G3608 Engines Engine Oil Pan - Remove
Generator Set Control Panel for Switchgear Conversion Service Mode
3612 and 3616 Engines Engine Oil Filter Elements - Remove and Install
3054 Engine Valve Mechanism Cover
3054 and 3056 Industrial and Generator Set Engines Engine Oil Pump
Generator Set Control Panel for Switchgear Conversion Units Mode
3408E and 3412E Engines for Caterpillar Built Machines Front Cover - Remove
797 Off-Highway Truck Hydraulic System Relief Valve (Hoist)
3408E and 3412E Engines for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
Generator Set Control Panel for Switchgear Conversion Accessing Diagnostic Information
3054 and 3056 Industrial and Generator Set Engines Water Outlet Manifold - Remove
3054 and 3056 Industrial and Generator Set Engines Water Outlet Manifold - Install
SR4 HV and SR4B HV Generators Insulation - Test
Generator Set Control Panel for Switchgear Conversion Troubleshooting Diagnostic Codes
3054 Engine for Caterpillar Built Machines Cylinder Liner - Remove
3054 Engine for Caterpillar Built Machines Cylinder Liner - Install