Engine Oil Relief Valve - Remove and Install
Removal Procedure
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove two bolts (1) that fasten the engine oil relief valve to the engine oil pump.
Show/hide table
Illustration 1 | g00552240 |
- Remove bolt (3) that holds engine oil relief valve (4) in position.
- Remove engine oil relief valve (4) and the gasket from the engine. Inspect the condition of the gasket. Replace the gasket, if necessary.
- Disconnect oil tube (2) and remove the O-ring seals from the oil tube.
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install new O-ring seals on oil tube (2) and connect oil tube (2) to the engine oil pump.
Show/hide table
Illustration 2 | g00552240 |
- Put the gasket in position and install engine oil relief valve (4) on the engine.
- Install bolt (3) that holds engine oil relief valve (4) in position. Tighten bolt (3) to a torque of 44 N·m (33 lb ft).
- Install two bolts (1) that fasten the engine oil relief valve to the engine oil pump.
End By: Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Install".
Caterpillar Information System:
G3606 and G3608 Engines Engine Oil Pan - Install
3412E and C30 Marine Engines Walk-Around Inspection
3054 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove
3054 and 3056 Industrial and Generator Set Engines Cylinder Head Valves
G3606 and G3608 Engines Engine Oil Pan - Remove
Generator Set Control Panel for Switchgear Conversion Service Mode
3612 and 3616 Engines Engine Oil Filter Elements - Remove and Install
3054 Engine Valve Mechanism Cover
3412E and C30 Marine Engines Information Plate
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector Sleeve - Install
3406E Truck Engines Electrical Ground Stud
Generator Set Control Panel for Switchgear Conversion Harness Code Mode
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Install
Generator Set Control Panel for Switchgear Conversion Tattletale Mode
3608 Engine Engine Oil Pan - Disassemble
3054 Engine for Caterpillar Built Machines Crankshaft Pulley - Remove and Install
3054 and 3056 Industrial and Generator Set Engines Engine Oil Pump
Generator Set Control Panel for Switchgear Conversion Units Mode
3408E and 3412E Engines for Caterpillar Built Machines Front Cover - Remove
797 Off-Highway Truck Hydraulic System Relief Valve (Hoist)
3408E and 3412E Engines for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
Generator Set Control Panel for Switchgear Conversion Accessing Diagnostic Information
3054 and 3056 Industrial and Generator Set Engines Water Outlet Manifold - Remove
3054 and 3056 Industrial and Generator Set Engines Water Outlet Manifold - Install