Housing (Front) - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | Loctite Gasket Sealant No. 2 | - |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Replace the gasket.
- Apply Tooling (A) to the bottom portion of the gasket.
Show/hide table
Illustration 1 g00549821 - If necessary, install the studs (not shown) to the back of the front housing (2) that holds the fuel injection pump in position. Tighten the studs to a torque of
11 N·m (97 lb in) . Install the gasket and front housing (2). Cut the gasket to the correct length, if necessary. - Install bolts (3) that hold the engine oil pan to the bottom of the front housing. Tighten the bolts to a torque of
22 N·m (16 lb ft) .Show/hide tableIllustration 2 g00549819 Show/hide tableIllustration 3 g03549798 - Install all bolts (1) that fasten the front housing (2) to the cylinder block and to the oil pan. Tighten bolts (1) to a torque of
22 N·m (16 lb ft) using the sequence in Illustration 3.Note: Ensure that the bottom of the front housing is aligned with the bottom of the cylinder block.
End By:
- Install the camshaft gear.
- Install the front gear group.
- Install the engine oil pan.
Caterpillar Information System:
3054 Engine for Caterpillar Built Machines Housing (Front) - Remove
SR4 HV and SR4B HV Generators Before Starting Engine
Generator Set Control Panel for Switchgear Conversion Component Location
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Remove
3408E and 3412E Engines for Caterpillar Built Machines Fuel Transfer Pump
3606 and 3608 Engines General Information (Lubrication System)
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Disassemble
Generator Set Control Panel for Switchgear Conversion Clear/Mode Switch - Troubleshoot
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Install
Generator Set Control Panel for Switchgear Conversion Charging System - Test
Generator Set Control Panel for Switchgear Conversion CID 0263 FMI 04 Sensor Power Supply Voltage Below Normal - Test
G3408 and G3412 Engines Governor Linkage
3054 Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
SR4 HV and SR4B HV Generators Walk-Around Inspection
3054 Truck Engine Rocker Shaft and Pushrod - Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Disassemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Assemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank
3054 Truck Engine Cylinder Head - Remove - 3054 and 3054B Engines
3054 Truck Engine Cylinder Head - Install - 3054 and 3054B Engines
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Assemble
G3408 and G3412 Engines Actuator Linkage