Housing (Front) - Remove
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
- Remove the front gear group. Refer to Disassembly and Assembly, "Gear Group (Front) - Remove".
- Remove the camshaft gear. Refer to Disassembly and Assembly, "Camshaft Gear - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove all bolts (1) that fasten the front housing (2) to the cylinder block.
Show/hide table
Illustration 2 g00549821 - Remove bolts (3) that hold the oil pan to the bottom of front housing (2).
- Remove front housing (2) and the gasket.
Show/hide table
Illustration 1 | g00549819 |
Caterpillar Information System:
SR4 HV and SR4B HV Generators Before Starting Engine
Generator Set Control Panel for Switchgear Conversion Component Location
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Remove
3408E and 3412E Engines for Caterpillar Built Machines Fuel Transfer Pump
3606 and 3608 Engines General Information (Lubrication System)
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Disassemble
Generator Set Control Panel for Switchgear Conversion Clear/Mode Switch - Troubleshoot
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Install
Generator Set Control Panel for Switchgear Conversion Charging System - Test
Generator Set Control Panel for Switchgear Conversion CID 0263 FMI 04 Sensor Power Supply Voltage Below Normal - Test
G3408 and G3412 Engines Governor Linkage
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 06 Alarm (Action) Current Above Normal - Test
3054 Engine for Caterpillar Built Machines Housing (Front) - Install
3054 Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
SR4 HV and SR4B HV Generators Walk-Around Inspection
3054 Truck Engine Rocker Shaft and Pushrod - Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Disassemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Assemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank
3054 Truck Engine Cylinder Head - Remove - 3054 and 3054B Engines
3054 Truck Engine Cylinder Head - Install - 3054 and 3054B Engines
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Assemble