Flywheel - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 138-7575     | Link Bracket     | 1     |
Show/hide table
Always wear protective gloves when handling parts that have been heated. |
- If flywheel ring gear (5) was removed, heat flywheel ring gear (5) to a temperature of 250 °C (480 °F).
Note: Do not use a torch to heat the flywheel ring gear.
Show/hide table
Illustration 1 | g00803517 |
Typical Example. Different Lifting device shown than what is called out in the table. |
- Install flywheel ring gear (5) on flywheel (1) .
Note: Ensure that the chamfer of the flywheel ring gear is in the correct position on the flywheel.
- Install Tool (A) and a suitable lifting device on flywheel (1) and position flywheel (1) in the flywheel housing. The weight of flywheel (1) and flywheel ring gear (5) is 53 kg (120 lb).
- Install six bolts (2) and the washers that hold flywheel (1) in position. Tighten the bolts to a torque of 105 N·m (77 lb ft).
Show/hide table
Illustration 2 | g00546793 |
- Put bearing housing (4) in position on the flywheel. Install four bolts (3) that fasten bearing housing (4) to the flywheel.
- Refer to the Specifications Module, "Flywheel" topic for information on inspecting the flywheel.
Caterpillar Information System:
Guidelines For 3600 Heavy Fuel Oil (HFO) Engines{1000} Guidelines For 3600 Heavy Fuel Oil (HFO) Engines{1000}
3054 Engine for Caterpillar Built Machines Flywheel - Remove
3054 Engine for Caterpillar Built Machines Camshaft - Remove and Install
3054 and 3056 Industrial and Generator Set Engines Water Temperature Regulator - Remove and Install
Electronic Modular Control Panel II+ (EMCP II+) Pulse Width Modulated (PWM) Sensor - Test
3612 and 3616 Fast Vessel Engines Cooling System Coolant (ELC) - Change
3408E and 3412E Engines for Caterpillar Built Machines Speed/Timing Sensor - Remove and Install
G3606 and G3608 Engines Prelubrication Oil Pump - Assemble
3600 and C280 Diesel Engine Fluids Recommendations Crude Fuel Oil
3054 and 3056 Industrial and Generator Set Engines Water Pump - Assemble
Electronic Modular Control Panel II+ (EMCP II+) Block Diagram of Generator Set Control
EMCPII+ for Gas Engines Connector Contact Identification of Generator Set Control
3054 and 3056 Industrial and Generator Set Engines Front Cover - Remove and Install
G3606 and G3608 Engines Lubrication Metering Pump - Remove and Install
3054 Engine for Caterpillar Built Machines Front Cover - Install
G3606 and G3608 Engines Engine Oil Pump - Remove
3054 Engine for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
3406E Truck Engine Housing (Front)
3408E and 3412E Engines for Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
3054 Engine for Caterpillar Built Machines Engine Oil Pan - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Pressure Sensor - Remove and Install
3176C Engine S·O·S Oil Analysis
3176C Engine Safety Signs and Labels
3408E and 3412E Engines for Caterpillar Built Machines Fuel Temperature Sensor - Remove and Install