Inlet Manifold - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the gaskets. Replace the gaskets, if necessary.
- Position gaskets (11) and inlet manifold (14) on the cylinder head.
Note: Ensure that the front gaskets and the rear gaskets are installed with the notch at the top left side. The center gasket can be installed in either way.
Show/hide table
Illustration 1 | g00545514 |
Typical example |
Show/hide table
Illustration 2 | g00545513 |
Typical example |
- Install bolts (13) that hold inlet manifold (14) on the cylinder head.
- Position the turbocharger support on the side of the inlet manifold (14) .
- Install bolts (12) that hold the turbocharger support.
- Connect boost pressure inlet (10) to inlet manifold (14) .
- Install gasket (4) and elbow (2) with four bolts (3) on inlet manifold (14) .
- Connect hose assembly (9) to the turbocharger.
- Tighten two hose clamps (8) .
- Place the bracket for fuel line (6) in position and install two bolts (7) .
- Connect fuel line (6) to the air inlet heater.
- Connect electrical connector (5) for the air inlet heater, if necessary.
Caterpillar Information System:
3606 and 3608 Engines Cooling System Operation
3612 and 3616 Fast Vessel Engines Hourly Performance Log
3054 and 3056 Industrial and Generator Set Engines Inlet Manifold - Remove
3054 Engine for Caterpillar Built Machines Turbocharger - Assemble
G3606 and G3608 Engines Water Pump Seal - Remove
3054 Engine for Caterpillar Built Machines Turbocharger - Disassemble
3054 Engine for Caterpillar Built Machines Turbocharger - Install
3054 Engine for Caterpillar Built Machines Turbocharger - Remove
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Pump - Install
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler - Install
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Pump - Remove
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Nozzles - Install
3054 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
G3606 and G3608 Engines Water Pump Seal - Install
3612 and 3616 Fast Vessel Engines Engine Mounts - Check
3054 Engine for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
3412E and C30 Marine Engines Front Power Take-Off (FPTO)
3054 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump Drive - Remove
3054 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
3612 and 3616 Fast Vessel Engines Air Shutoff - Test
3054 Engine for Caterpillar Built Machines Engine Oil Pump - Remove
3054 Engine for Caterpillar Built Machines Alternator - Remove and Install
3412E and C30 Marine Engines Electronic Control System