Turbocharger - Assemble
Assembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the gaskets. Replace the gaskets, if necessary.
- Assemble cartridge (7) and turbine housing (10) .
Show/hide table
Illustration 1 | g00545505 |
Typical example |
Show/hide table
Illustration 2 | g00545464 |
Typical example |
- Install three clamps (9) .
- Apply 5P-3931 Anti-Seize Compound to six bolts (8). Tighten the bolts to a torque of 19 ± 1 N·m (14 ± 1 lb ft).
- Assemble compressor housing (6) and cartridge (7) .
Show/hide table
Illustration 3 | g00545463 |
Typical example |
- Install three clamps (5) .
- Apply 5P-3931 Anti-Seize Compound to six bolts (4). Tighten the bolts to a torque of 15 ± 4 N·m (11 ± 3 lb ft).
- Install hose assembly (3) and the gasket.
Show/hide table
Illustration 4 | g00545460 |
Typical example |
- Install two bolts (2) .
- Install elbow (1) and the O-ring seals.
End By: Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".
Caterpillar Information System:
G3606 and G3608 Engines Water Pump Seal - Remove
3054 Engine for Caterpillar Built Machines Turbocharger - Disassemble
3054 Engine for Caterpillar Built Machines Turbocharger - Install
3054 Engine for Caterpillar Built Machines Turbocharger - Remove
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Pump - Install
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler - Install
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Pump - Remove
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Nozzles - Install
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Nozzles - Remove
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler - Remove
3054 Engine for Caterpillar Built Machines Fuel Injection Lines - Remove and Install
SR4 HV and SR4B HV Generators Glossary
3054 and 3056 Industrial and Generator Set Engines Inlet Manifold - Remove
3612 and 3616 Fast Vessel Engines Hourly Performance Log
3606 and 3608 Engines Cooling System Operation
3054 and 3056 Industrial and Generator Set Engines Inlet Manifold - Install
3054 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
G3606 and G3608 Engines Water Pump Seal - Install
3612 and 3616 Fast Vessel Engines Engine Mounts - Check
3054 Engine for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
3412E and C30 Marine Engines Front Power Take-Off (FPTO)
3054 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Guides - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump Drive - Remove
3054 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install