Fuel Transfer Pump - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Inspect the condition of the gasket. Replace the gasket, if necessary.
Show/hide table
 | |
| Illustration 1 | g00543616 |
Typical example | |
- Ensure that the rocker arm for the fuel transfer pump is not under pressure.
- Install the gasket and fuel transfer pump (2). If fuel transfer pump (2) is difficult to install, rotate the crankshaft.
- Install two lock plates (4) .
- Install four bolts (3). Tighten the bolts to a torque of 22 N·m (16 lb ft).
- Connect two fuel lines (1) .
- Loosen the vent screw on the top of the fuel filter and operate the priming lever on the fuel transfer pump in order to remove the air from the fuel system. When only fuel comes out of the vent screw, tighten the vent screw.
- Start the engine and check the fuel system for fuel leaks and for air leaks.
Caterpillar Information System:
3606 and 3608 Engines Lubrication System Operation
3406E Generator Set Engines Instrument Panel - Inspect
G3606 and G3608 Engines Crankcase Explosion Relief Valve - Remove and Install
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Remove
G3606 and G3608 Engines Engine Oil Filler - Remove and Install
PM820, PM822, and PM825 Cold Planer Operation
G3408 and G3412 Engines Gas Engine Ignition
3412E and C30 Marine Engines Cooling System
3412E and C30 Marine Engines Air Starting System
G3606 and G3608 Engines Turbocharger - Disassemble
3606 and 3608 Engines Air Inlet and Exhaust System Operation
C280 Marine Engines Fuel System Operation
Gas Engine Driven Chiller Driveline Maintenance Interval Schedule
3406C (PEEC III) Truck Engines Troubleshooting
3600 Distillate Fuel Engines Trend Data - Record
365B and 365B Series II Excavators Hydraulic System Graphic Color Codes
3304B and 3306B Engines for Caterpillar Built Machines Cylinder Liner - Install
G3606 and G3608 Engines Water Pump - Remove
797 Off-Highway Truck Steering System Check Valve (Steering)
G3606 and G3608 Engines Water Pump - Install
G3606 and G3608 Engines Water Pump - Disassemble
3412E and C30 Marine Engines Air Starting System
G3606 and G3608 Engines Water Pump - Assemble
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Disassemble