Electric Starting Motor - Remove and Install
Removal Procedure
- Place an identification mark on all electrical wires that are connected to the starting motor. Disconnect the electrical wires from the starting motor.
- Remove nuts (1) from the studs that are in the flywheel housing.
Show/hide table
Illustration 1 | g00543044 |
- Remove electric starting motor (2) from the flywheel housing.
- Remove ring (3) from the flywheel housing.
Note: Place an index mark on the ring for installation purposes.
Show/hide table
Illustration 2 | g00543045 |
Installation Procedure
- Install ring (3) into the flywheel housing.
Note: Ensure that the ring is installed according to the index mark that was made during the removal process.
Show/hide table
Illustration 3 | g00543045 |
- Install electric starting motor (2) on the flywheel housing.
Show/hide table
Illustration 4 | g00543044 |
- Install nuts (1) on the studs.
Caterpillar Information System:
G3606 and G3608 Engines Turbocharger - Install
3054 Engine for Caterpillar Built Machines Fan Drive - Install
3606 and 3608 Engines Fuel Shutoff
3054 Engine for Caterpillar Built Machines Fan Drive - Remove
G3606 and G3608 Engines Turbocharger - Remove
3606 and 3608 Engines Pressure Switch
3054 Engine for Caterpillar Built Machines Fan - Remove and Install
G3606 and G3608 Engines Actuator (Heinzman) - Remove and Install
3054 Truck Engine Exhaust Manifold - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Hydraulic Pump Drive
G3408 and G3412 Engines Exhaust Manifold
3412E, C30 and C32 Marine Engines Turbocharger - Install
C280 Marine Engines Fuel System Operation
3606 and 3608 Engines Air Inlet and Exhaust System Operation
G3606 and G3608 Engines Turbocharger - Disassemble
3412E and C30 Marine Engines Air Starting System
3412E and C30 Marine Engines Cooling System
G3408 and G3412 Engines Gas Engine Ignition
PM820, PM822, and PM825 Cold Planer Operation
G3606 and G3608 Engines Engine Oil Filler - Remove and Install
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Remove
G3606 and G3608 Engines Crankcase Explosion Relief Valve - Remove and Install
3406E Generator Set Engines Instrument Panel - Inspect
3606 and 3608 Engines Lubrication System Operation