A13 Auger Caterpillar


Chain - Inspect/Adjust

Usage:

A13 ACY



Illustration 1g00568493

  • Remove the side cover of the drive unit.



      Illustration 2g00568494

    1. Inspect the chain for wear or for damage. Replace the chain, if necessary.

    1. Check the tension of the chain. The chain should deflect about 3.2 mm (0.13 inch) between the two gears. If the tension of the chain needs to be adjusted, perform the following procedure.



        Illustration 3g00568507

      1. Loosen the two bolts (1) for the motor and the two bolts (3) for the adjusting cam.

      1. Turn the center weldnut (2) on the cam in order to adjust the tension of the chain.

      1. Tighten the two bolts for the adjusting cam.

      1. Tighten the two bolts for the motor.

    1. Install the side cover.
  • Caterpillar Information System:

    3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Gear - Remove and Install
    3176C and 3196 Engines For Caterpillar Built Machines Camshaft Gear - Remove and Install
    5130 Excavator Hydraulic System Solenoid Valve (Bottom Dump)
    5130 Excavator Hydraulic System Solenoid Valve (Swing Parking Brake)
    3176C and 3196 Engines For Caterpillar Built Machines Accessory Drive - Assemble
    3176C and 3196 Engines For Caterpillar Built Machines Accessory Drive - Disassemble
    302.5 Mini Hydraulic Excavator Bucket Linkage - Lubricate
    5130 Excavator Hydraulic System Solenoid Valve (Boom Float)
    3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Rear Seal Carrier - Remove and Install
    317B Excavator Machine System and Attachment Specifications Lines (Travel Motor)
    5130 Excavator Hydraulic System Relief Valve (Pilot)
    3176C and 3196 Engines For Caterpillar Built Machines Turbocharger - Install
    315B Excavator Excavator Systems Track Carrier Roller - Assemble
    A13 Auger Chain - Lubricate
    3176C and 3196 Industrial Engines Electronic Control Module - Remove and Install
    315B Excavator Excavator Systems Track Roller - Disassemble
    302.5 Mini Hydraulic Excavator Cooling System Hoses - Inspect
    315B Excavator Excavator Systems Track Roller - Assemble
    315B Excavator Excavator Systems Track Roller - Install
    302.5 Mini Hydraulic Excavator Cooling System Coolant Level - Check
    302.5 Mini Hydraulic Excavator Blade Linkage - Lubricate
    302.5 Mini Hydraulic Excavator Fuel Tank Water and Sediment - Drain
    5130 Excavator Hydraulic System Control Valve (Travel Parking Brake Dual Pressure)
    320B Excavator Machine System Specifications Fuel Tank
    Back to top
    The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
    CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.