Camshaft Position Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the harness assembly from camshaft position sensor (3).
- Remove bolt (1) and the washer.
- Remove camshaft position sensor (3) and bracket (2) as a unit from the front housing.
- Inspect the condition of the O-ring seal on camshaft position sensor (3). Replace the O-ring seal, if necessary.
Show/hide table
Illustration 1 | g01022875 |
Show/hide table
Illustration 2 | g01064053 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install camshaft position sensor (3) and bracket (2) as a unit into the front housing.
- Install bolt (1) and the washer.
- Connect the harness assembly to camshaft position sensor (3).
- Calibrate the engine speed-timing. Refer to Electronic Troubleshooting for more information.
Show/hide table
Illustration 3 | g01064053 |
Show/hide table
Illustration 4 | g01022875 |
Caterpillar Information System:
3114, 3116 and 3126 MUI Engine Governors Dual Horsepower (Type VII)
3176C and 3196 Industrial Engines Compression Brake - Remove
3406C (PEEC III) Truck Engines Basic Block
3114, 3116 and 3126 MUI Engine Governors Dual Horsepower (Type VI)
3114, 3116 and 3126 MUI Engine Governors Governor Bumper Spring (Some Type IV)
3114, 3116 and 3126 MUI Engine Governors Governor Bias Spring (Most Types IV, V, and VI)
G3300 Engines Governors and Actuators
3114, 3116 and 3126 MUI Engine Governors Dashpot (Types I, III, IV, V, VI, and VII)
3114, 3116 and 3126 MUI Engine Governors Governor Servo (Types I, III, IV, V, VI, and VII)
3406C (PEEC III) Truck Engines Air Inlet and Exhaust System
3114, 3116 and 3126 MUI Engine Governors Fuel Ratio Control (Types V, VI, and VII)
3114, 3116 and 3126 MUI Engine Governors Fuel Ratio Control (Types I and IV)
3114, 3116 and 3126 MUI Engine Governors Fuel Transfer Pump
3114, 3116 and 3126 MUI Engine Governors Governor (Type I) - Disassemble
3176C and 3196 Engines For Caterpillar Built Machines Turbocharger - Remove
3176C and 3196 Engines For Caterpillar Built Machines Turbocharger - Install
3500 Spark Ignited Engines Piston and Rings
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Rear Seal Carrier - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Accessory Drive - Disassemble
3406C (PEEC III) Truck Engines Cooling System
3176C and 3196 Engines For Caterpillar Built Machines Accessory Drive - Assemble
3176C and 3196 Engines For Caterpillar Built Machines Camshaft Gear - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Gear - Remove and Install
3176C and 3196 Industrial Engines Electronic Control Module - Remove and Install