Speed/Timing Sensor - Remove and Install
- 从夹子 (3) 上拆下螺栓 (1) 和垫圈。
- 断开转速/正时传感器接头 (2)。
- 拆下转速/正时传感器 (3) 。
Show/hide table
图 2 g00518484 - 将 O 形密封圈 (5) 从转速/正时传感器 (4) 上拆下。
- 安装时延长滑动头 (6)。
Show/hide table
图 1 | g00518483 |
- 检查 O 形密封圈的状况。 必要时,更换密封圈。
Show/hide table
注意 编号 必须有 1 个活塞位于压缩冲程上止点或者排气冲程上止点。 安装传感器之后,必须再次标定电子正时。
注: 请参阅故障诊断与排除, "发动机转速/正时传感器"的标定。
Show/hide table图 3 g00518484 - 安装 O 形密封圈 (5) 并延长滑动头 (6)。
Show/hide table
图 4 g00518485 注: 安装前,确保可经由前壳体内的转速/正时传感器开口看到齿轮齿顶部。 请参阅图 4。
Show/hide table图 5 g00518483 - 安装转速/正时传感器 (4)。 将传感器上紧到
40 ± 5 N·m (30 ± 4 lb ft) 的扭矩。 - 连接转速/正时传感器接头 (2)。
- 用螺栓 (1) 和垫圈安装夹子 (3) 。
- 重新标定正时。
Caterpillar Information System:
3176C and 3196 Industrial Engines Engine Oil Pressure Sensor - Remove and Install
G3300 Engines Cooling System Coolant (DEAC) - Change
C-10 and C-12 Truck Engines Compression Brake
G3500 Engines Camshaft
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Oil in Cooling System
G3300 Engines Ignition System Spark Plugs - Inspect/Replace
318B Excavator Machine System Specifications Track Roller (Single Flange)
3500 Spark Ignited Engines Engine Design
3406E On-Highway Engine Engine Oil Pressure Sensor - Remove and Install
3406E On-Highway Engine Coolant Temperature Sensor - Remove and Install
3406C (PEEC III) Truck Engines Glossary of Electronic Control Terms
3406E Engine Speed/Timing Sensor - Remove and Install
3524B Engines for Off-Highway Trucks Fuel in Cooling System
3176C Engine Cooling System Coolant (ELC) - Change
3500B and 3500B High Displacement Generator Set Engines Oil Contains Coolant
3516B Engine for Caterpillar Built Machines Engine Has Early Wear
3524B Engines for Off-Highway Trucks Low Engine Oil Pressure
3606 and 3608 Engines Exhaust Manifold
3524B Engines for Off-Highway Trucks Coolant Temperature Is Too High
3516B Engine for Caterpillar Built Machines Fuel Dilution of Engine Oil
3406E On-Highway Engine Turbocharger - Assemble
3500B and 3500B High Displacement Generator Set Engines Exhaust Temperature Is Too High
Installation And Initial Start Up Procedures For G3300 And G3400 Engines{1000} Installation And Initial Start Up Procedures For G3300 And G3400 Engines{1000}
3612 and 3616 Engines Water Temperature Regulator